1968 Yenko Clone Emblems

cDuck28Z · #1 03-28-2007, 01:32 AM

I recently acquired a '68 RS/SS that had been painted with '69 Yenko stripes and had a bran new 427. i noticed on the side that there are many holes in the fender for what appears to be for emblems. I took a picture with my phone so you could get a good visual. I also took dimensions. They are measured center to center and wrap around the curve in the fender. Look at the picture to understand what i just said lol! Anyway, i would like to put Yenko emblems on her, but im not sure what emblems would go where. Any help would be greatly appreciated!!

**Dave Rifkin** · #2 03-28-2007, 03:33 PM

The "Little Dipper"?

camarojoe · #3 03-28-2007, 03:59 PM

Looks like holes for the standard "Camaro" badge and a Yenko shield emblem directly below.

cDuck28Z · #4 03-29-2007, 06:58 AM

I was thinking an "SS" badge on the bottom two holes, the standard "Camaro" Badge in the middle, and the "Yenko" emblem up top. But i cant figure out if the holes will line up or anything

cDuck28Z · #5 04-02-2007, 05:44 AM

anyone else have any ideas as to what these hole could be for? Im stumped

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.