1968 Yenko Clone Emblems
 

I recently acquired a '68 RS/SS that had been painted with '69 Yenko stripes and had a bran new 427. i noticed on the side that there are many holes in the fender for what appears to be for emblems. I took a picture with my phone so you could get a good visual. I also took dimensions. They are measured center to center and wrap around the curve in the fender. Look at the picture to understand what i just said lol! Anyway, i would like to put Yenko emblems on her, but im not sure what emblems would go where. Any help would be greatly appreciated!!

http://i60.photobucket.com/albums/h2...nsionscopy.jpg

Re: 1968 Yenko Clone Emblems
 

The "Little Dipper"? https://www.yenko.net/ubbthreads/imag...lins/dunno.gif

Re: 1968 Yenko Clone Emblems
 

Looks like holes for the standard "Camaro" badge and a Yenko shield emblem directly below.

Re: 1968 Yenko Clone Emblems
 

I was thinking an "SS" badge on the bottom two holes, the standard "Camaro" Badge in the middle, and the "Yenko" emblem up top. But i cant figure out if the holes will line up or anything

Re: 1968 Yenko Clone Emblems
 

anyone else have any ideas as to what these hole could be for? Im stumped