The Supercar Registry > Search Forums Search Results

User Name Remember Me? Password

Page 1 of 19 1 2 3 11 > Last »

Showing results 1 to 25 of 457 Search took 0.01 seconds. Search: Posts Made By: X66 714

Forum: Technical & Restoration Yesterday, 08:08 PM

Replies: 5 Tire Code? Views: 234 Posted By X66 714 Thank you Steve....Joe Thank you Steve....Joe

Forum: Technical & Restoration 11-12-2024, 12:36 PM

Replies: 12 Painting End of Control Arms to Look Like Bare Steel Views: 817 Posted By X66 714 It would depend on the part. That driveshaft was... It would depend on the part. That driveshaft was soaked in eveporust for 24 hours, rinsed, dried & then 0000 steel wool. Stripes painted & then clear coated everything. Some parts needed to go in the...

Forum: Technical & Restoration 11-12-2024, 01:39 AM

Replies: 12 Painting End of Control Arms to Look Like Bare Steel Views: 817 Posted By X66 714 Any of the items I needed to look like raw steel,... Any of the items I needed to look like raw steel, I used a satin clear on after I made the steel look correct. This is my drive shaft...Joe

Forum: Supercar/Musclecar Discussion 11-06-2024, 08:12 PM

Replies: 5 Best 1967, correct appearing, rear antenna kit/assembly Views: 430 Posted By X66 714 You might try running an ad. Not everybody lives... You might try running an ad. Not everybody lives in the rust belt. Might find a good used one. I had to find one for my 69 when I restored it...Joe

Forum: Lounge 11-05-2024, 03:22 PM

Replies: 21 Election Day... Views: 2,013 Posted By X66 714 We mailed ours back a couple of weeks ago.....Joe We mailed ours back a couple of weeks ago.....Joe

Forum: Ebay & other seen ads section 11-02-2024, 08:05 PM

Replies: 7 Unrestored '69 SC/Rambler, #s 390/4-sp Views: 1,738 Posted By X66 714 That's not a cheap VW bus in the back... That's not a cheap VW bus in the back ground....Joe

Forum: Supercar/Musclecar Discussion 10-27-2024, 11:29 PM

Replies: 51 I finally purchased a 1970 'cuda Views: 34,024 Posted By X66 714 Drawing Drawing

Forum: Supercar/Musclecar Discussion 10-24-2024, 12:31 PM

Replies: 51 I finally purchased a 1970 'cuda Views: 34,024 Posted By X66 714 Here's some more pictures. I have the correct... Here's some more pictures. I have the correct fender mounted turn signal lights. Other than that, I think the exterior is done. I still have the rear speaker to install, repair the RH seat track &...

Forum: Supercar/Musclecar Discussion 10-24-2024, 02:38 AM

Replies: 51 I finally purchased a 1970 'cuda Views: 34,024 Posted By X66 714 Paint is over 15 years old. The guy who looked at... Paint is over 15 years old. The guy who looked at the car for me described the paint at about 8.5. Very little body work has been done, possibly both lower quarter panels. It was painted by Rainbow...

Forum: Supercar/Musclecar Discussion 10-23-2024, 09:45 PM

Replies: 51 I finally purchased a 1970 'cuda Views: 34,024 Posted By X66 714 I guess I needed to follow up on my own post. I... I guess I needed to follow up on my own post. I didn't get the car till mid February & ever since I've been diong repair, replacements or modifications to it. I've put only about 150 miles on it...

Forum: Technical & Restoration 10-14-2024, 05:27 AM

Replies: 6 Fuel Pump Cosmetic Restoration ????? Views: 1,566 Posted By X66 714 100% Fred Ballard. Sadly Goathill screwed... 100% Fred Ballard. Sadly Goathill screwed me also. Nobody should've ever got screwed again by Goathill. Plenty of info here about it....Joe

Forum: Technical & Restoration 10-11-2024, 07:19 PM

Replies: 19 Compressed Air Piping Views: 2,933 Posted By X66 714 I ran all the piping high & when it stubs out at... I ran all the piping high & when it stubs out at the wall each one has a ball valve shut off & also a drain about a foot below the tee coming out of the wall....Joe

Forum: Technical & Restoration 10-11-2024, 03:53 PM

Replies: 19 Compressed Air Piping Views: 2,933 Posted By X66 714 I used black iron pipe throughout the garage also... I used black iron pipe throughout the garage also behind the walls. I used T111 exterior siding inside held on with sheet rock screws. I collect signs so that's why the siding. The screws so you can...

Forum: Lounge 10-10-2024, 12:11 AM

Replies: 3 Gibson... Views: 961 Posted By X66 714 Looks like our Norwegian Forest Cat, Cookie....Joe Looks like our Norwegian Forest Cat, Cookie....Joe

Forum: Supercar/Musclecar Discussion 09-27-2024, 12:58 AM

Replies: 13 What's it worth? 1969 Camaro Pace Car Views: 2,175 Posted By X66 714 That type of body work is crazy money out here in... That type of body work is crazy money out here in Az. When I was looking at rusty cudas it was like 15-18k for a "buildable" car. Add 20-30k plus for body work & another 25k plus for a paint job, it...

Forum: Technical & Restoration 09-26-2024, 01:52 PM

Replies: 6 Stripping paint/rust from body Views: 1,559 Posted By X66 714 They used a plastic media on my Camaro. You could... They used a plastic media on my Camaro. You could see all the crayon marks on the firewall. I didn't redo them, I documented them with pictures as it was getting painted over again. You may have to...

Forum: Muscle Car and Corvette Nationals 09-26-2024, 02:41 AM

Replies: 35 First Time at MCACN Views: 7,227 Posted By X66 714 The Crown was good. I stayed there the 1st time I... The Crown was good. I stayed there the 1st time I went. I wasn't fond of the walk down the sidewalk to the show. Cars wizzing by was cold by my standards. Enjoy the show. It's really fun.....Joe

Forum: Muscle Car and Corvette Nationals 09-25-2024, 03:46 PM

Replies: 35 First Time at MCACN Views: 7,227 Posted By X66 714 Andy, I usually stay at the Embassy. My fight... Andy, I usually stay at the Embassy. My fight lands at about 11am most of the time. I'm sure you're not going to be stuck with you luggage. Call your hotel for details...Joe

Forum: Muscle Car and Corvette Nationals 09-21-2024, 02:46 PM

Replies: 35 First Time at MCACN Views: 7,227 Posted By X66 714 I like going to MCACN although I'm going to miss... I like going to MCACN although I'm going to miss this year. If you're flying in to O'hare, the shuttles will take you to the hotels arross the street from the Steven Center, providing you got one of...

Forum: In Memoriam 09-12-2024, 12:31 AM

Replies: 14 Jeff Dickey (ACELR8) Views: 2,309 Posted By X66 714 Jeff Dickey (ACELR8) I thought I would post about Jeff Dickey. He was a member of this group some years back. Jeff passed today of medical issues. He was only a few days shy of being 61 years old. He was the owner of JD...

Forum: Technical & Restoration 09-08-2024, 04:49 PM

Replies: 5 Full re-wire of 68 Nova- advice/help Views: 773 Posted By X66 714 I used American Auto Wire.....No regrets......Joe I used American Auto Wire.....No regrets......Joe

Forum: Supercar/Musclecar Discussion 08-26-2024, 09:49 PM

Replies: 131 Sticky: Our Cars Birthday- Born Date Views: 64,199 Posted By X66 714 On Aug 28, 1969 my 1969 Camaro SS396 will be 55... On Aug 28, 1969 my 1969 Camaro SS396 will be 55 years old. I purchased it in spring of 1981 which means I've owned it for 43 years. It was a daily driver for many years & I managed to put 80,000...

Forum: Technical & Restoration 08-22-2024, 12:44 PM

Replies: 2 67 Camaro steering column Views: 537 Posted By X66 714 Here's some info from CRG...Joe ... Here's some info from CRG...Joe http://www.camaros.org/forum/index.php?topic=13171.0

Forum: Supercar/Musclecar Discussion 08-19-2024, 10:21 PM

Replies: 5 Numbers are to be recorded Views: 1,542 Posted By X66 714 I did my own. If you want to send me a pm with... I did my own. If you want to send me a pm with your e-mail address I can send what I did...Joe

Forum: Technical & Restoration 08-16-2024, 01:16 PM

Replies: 2 Correct Finish LOOK: Sway Bars, Leaf Springs, Center Link Views: 983 Posted By X66 714 These were done with a wire wheel on a drill to... These were done with a wire wheel on a drill to start with. After that they were soaked in Evapo-rust. Rinsed & dried. Went over them with 0000 steel wool & sprayed them with satin clear. I'm pretty...

Showing results 1 to 25 of 457

Page 1 of 19 1 2 3 11 > Last »

Forum Jump User Control Panel Private Messages Subscriptions Who's Online Search Forums Forums Home General Discussion     Supercar/Musclecar Discussion     My Garage & Journey     Member's Rides     Supercar Features     Other Muscle     Technical & Restoration     Pit Area - Racing     Sponsors Forum     Preservation forum     Lounge     AMC     Buick     Chevrolet     Ford-Mercury     Pontiac     Mopar     Olds     Day 2 stuff-modified cars     L78/L89 specific Forum     5th & 6th Gen Camaro's     Acadian Beaumont and Canso     In Memoriam     Garages/shops.. Dealer Specific Discussion     Yenko Chevrolet     Shelby     COPO - United States     COPO - Canada     Baldwin-Motion Performance     Berger Chevrolet     Fred Gibb Chevrolet     Nickey Chevrolet & Bill Thomas Performance     Misc. Dealers     Dick Harrell Sponsors     MK Insurance Co     Rusted Tires - One Call for Tires & Rims     Beem's Vapor Honing- Refinishing     Level One Restoration     Muscle Car and Corvette Nationals     Vintage Certification Events     Supercar Reunion     Other Events     Camaro Nationals- Morgantown,PA     Auctions Classified Section     Ebay & other seen ads section     Pay it Forward Classifieds     Supercars/Musclecars-For Sale         Supercars/Musclecars-Sold listings     Supercars/Musclecars-Wanted     Parts/Memorabilia - For Sale         Parts/Memorabilia - Sold listings     Parts/Memorabilia - Wanted Comments/Suggestions     Scammers/Fraudsters     Comments, Suggestions, Problems     Tutorials- How to instructions- Hidden features Supercar Registry     Supercar Registry