Go Back   The Supercar Registry > Search Forums


Showing results 1 to 25 of 41
Search took 0.00 seconds.
Search: Posts Made By: Rsconv68
Forum: Supercar/Musclecar Discussion 10-13-2024, 10:25 PM
Replies: 13
Views: 3,341
Posted By Rsconv68
While I’m no expert, the 0,2, and D are...

While I’m no expert, the 0,2, and D are inconsistent with the shown examples.
Forum: Supercar/Musclecar Discussion 10-09-2024, 04:56 AM
Replies: 6
Views: 1,684
Posted By Rsconv68
Courtesy of CRG ...

Courtesy of CRG
http://www.camaros.org/foreign.shtml
Forum: Technical & Restoration 10-07-2024, 03:57 AM
Replies: 8
Views: 758
Posted By Rsconv68
The fun part about discovery lies here, courtesy...

The fun part about discovery lies here, courtesy of CRG.
http://www.camaros.org/numbers.shtml
http://www.camaros.org/radiusrod.shtml
Forum: Supercar/Musclecar Discussion 09-27-2024, 04:05 AM
Replies: 13
Views: 1,933
Posted By Rsconv68
The going rate for a roller is 8-10. Since the...

The going rate for a roller is 8-10. Since the original engine is gone, I’d say 18 is beyond fair.
Forum: Technical & Restoration 09-26-2024, 02:42 AM
Replies: 6
Views: 1,421
Posted By Rsconv68
Whatever method you use, mask off those markings...

Whatever method you use, mask off those markings and you can hand apply whatever method you use on the rest of the car.
Forum: Technical & Restoration 09-22-2024, 05:59 AM
Replies: 7
Views: 959
Posted By Rsconv68
If you pull the engine, you can replace the rear...

If you pull the engine, you can replace the rear seals and all the gaskets. And clean the engine bay while it’s out.
Forum: Lounge 09-10-2024, 12:01 AM
Replies: 14
Views: 2,328
Posted By Rsconv68
That’s about the most generic non apology I have...

That’s about the most generic non apology I have seen in some time. No” free shipping if your order was delayed”, no olive branch of anything. I’m not sure how extending the sale is considered a...
Forum: Technical & Restoration 09-08-2024, 04:08 PM
Replies: 6
Views: 1,089
Posted By Rsconv68
IGO is correct, you have to pull the shaft out...

IGO is correct, you have to pull the shaft out fully and then depress the button.
Forum: Pontiac 09-08-2024, 04:06 PM
Replies: 15
Views: 2,178
Posted By Rsconv68
That looks almost like Tahoe Turquoise for the 67...

That looks almost like Tahoe Turquoise for the 67 Camaro.
Forum: Technical & Restoration 09-06-2024, 04:35 AM
Replies: 6
Views: 1,089
Posted By Rsconv68
You have to push the spring loaded button down...

You have to push the spring loaded button down and then a little bit more. Some are just stubborn.
Forum: Technical & Restoration 08-21-2024, 02:36 AM
Replies: 3
Views: 565
Posted By Rsconv68
I couldn’t find a kit, but you might be able to...

I couldn’t find a kit, but you might be able to find what you need here. Circa 1974 parts book.
Forum: Lounge 08-18-2024, 12:28 AM
Replies: 7
Views: 781
Posted By Rsconv68
Thinkware brand is what I have in my daily. It’s...

Thinkware brand is what I have in my daily. It’s easy to install and wire up. I saw a guy cut off a motorcycle rider and ended up giving the video clip to the police officer. She said it was the...
Forum: COPO - United States 08-10-2024, 03:33 PM
Replies: 170
Views: 234,674
Posted By Rsconv68
An undisputed and uncontradicted expert report by...

An undisputed and uncontradicted expert report by MacNeish concluded the car he inspected was not number 48 of the 69 Camaros produced. Indeed, it was not even a ZL1, worth no more than US$70,000....
Forum: Technical & Restoration 08-09-2024, 01:24 AM
Replies: 18
Views: 2,274
Posted By Rsconv68
Horn pictures

Here’s some pictures of the finished horns and what they typically look like disassembled. I even had him make me a low note horn….not available on my 68 convertible, but whatever. Looks cool, sounds...
Forum: Supercar/Musclecar Discussion 07-27-2024, 05:03 AM
Replies: 5
Views: 1,100
Posted By Rsconv68
I dreaded sending mine out in a box to some...

I dreaded sending mine out in a box to some person I don’t know, or risking t getting lost or stolen during shipping, so I went to his shop. Joe is the man. He’s in Pomona, Ca just a stones throw...
Forum: Supercar/Musclecar Discussion 06-29-2024, 02:55 AM
Replies: 14
Views: 3,070
Posted By Rsconv68
I know a guy who drove a “Vette”.

I know a guy who drove a “Vette”.
Forum: Supercar/Musclecar Discussion 06-16-2024, 02:32 AM
Replies: 1,104
Views: 1,720,524
Posted By Rsconv68
Pretty much the best “Stance” picture I have. It...

Pretty much the best “Stance” picture I have. It does sit a factory AIM specs now, after junking those “correct” aftermarket mono springs. I got a set of used ones.
Forum: Technical & Restoration 06-11-2024, 02:40 AM
Replies: 5
Views: 2,787
Posted By Rsconv68
I recommend a used and already painted one. It...

I recommend a used and already painted one. It probably looked and worked just fine at some point.
Forum: Technical & Restoration 06-09-2024, 08:41 PM
Replies: 4
Views: 2,717
Posted By Rsconv68
I found this for sale at Carlisle. This guy seems...

I found this for sale at Carlisle. This guy seems to always find the good stuff.
Forum: Lounge 05-30-2024, 02:08 AM
Replies: 2
Views: 2,657
Posted By Rsconv68
I see the Butternut Yellow one has them “ZL1”...

I see the Butternut Yellow one has them “ZL1” hubcaps��*����. Nicely done.
Forum: Technical & Restoration 05-08-2024, 02:40 AM
Replies: 11
Views: 4,967
Posted By Rsconv68
I’m no expert by any means, but I see the 37...

I’m no expert by any means, but I see the 37 definitely off compared to the many alternators I’ve seen. Even the ones at swap meets tossed in a pile have straight numbers. I’m curious what others...
Forum: Technical & Restoration 05-01-2024, 05:26 AM
Replies: 52
Views: 24,654
Posted By Rsconv68
Very nice. I helped a friend do his 72 in his...

Very nice. I helped a friend do his 72 in his garage. He had everything figured out except how to get the body back on. I called a friend with his tow truck and half the neighborhood was there taking...
Forum: Technical & Restoration 03-28-2024, 02:51 AM
Replies: 3
Views: 1,591
Posted By Rsconv68
Joe is the guy. https://jvrestorations.com/

Joe is the guy.
https://jvrestorations.com/
Forum: Technical & Restoration 03-21-2024, 03:36 AM
Replies: 1
Views: 968
Posted By Rsconv68
Here you go. Appears to be a 6 cylinder cable...

Here you go. Appears to be a 6 cylinder cable application.
Forum: Supercar/Musclecar Discussion 01-11-2024, 04:53 AM
Replies: 92
Views: 59,538
Posted By Rsconv68
I myself don’t care if it’s rebodied, as long as...

I myself don’t care if it’s rebodied, as long as the original drivetrain parts are there. To me, if the car was missing the drivetrain, it’s not worth the same. JMHO.
Showing results 1 to 25 of 41

 
Forum Jump

All times are GMT. The time now is 01:52 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

O Garage vBulletin Plugins by Drive Thru Online, Inc.