Front End Alignment shims needed

**enio45** · #1 03-19-2026, 07:06 PM

looking to buy some 15-20 front suspension alignment shims of the original style that i will restore. this is the style below. If i recall some had a small manufacturing logo on them - not necessary so long as the design is like what i have posted below.

while on the topic, what has been the acceptable finish on them - in the past i usually had them cleaned and preserved in the bare steel. thoughts?

Not that it matters much but these are for a 68 Camaro.

usually they are in 1/8, 1/16 and maybe 1/32.

Currently i have NO shims and lost my stash somewhere, thus the reason i need 15-20 in a variety of sizes to do the alignment.

**Charley Lillard** · #2 03-19-2026, 10:32 PM

I'm sure I have some. I'll try to dig around tomorrow.

**169indy** · #3 03-20-2026, 03:46 AM

They are still avail>?

Not sure if the finish could be altered to bare>?

**enio45** · #4 03-20-2026, 02:20 PM

Thank you - i did see those on the net - little rounded on the shoulders, probably have to media clean off the zinc. Good backup solution for what i need. I sure there are numerous of these in bins like i had......I'll see what Charlie comes up with and keep looking for a while.

**enio45** · #5 Yesterday, 11:35 PM

Have found a few - need more pls!!

The Following User Says Thank You to Charley Lillard For This Useful Post:
enio45 (03-20-2026)

The Following User Says Thank You to enio45 For This Useful Post:
169indy (03-20-2026)

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.