Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
|
Thread Tools | Display Modes |
|
#1
06-27-2021, 09:35 PM
|
|||
|
|||
1115263 ti coil question
Has anyone else seen these little holes by the threaded studs on a 263 coil? I know they reproduced these, but I never did take a good look at them. What were they for?
|
|
#2
06-27-2021, 09:41 PM
|
||||
|
||||
|
Hi. To catch lock washers I believe:
https://www.yenko.net/forum/showpost...56&postcount=5 Cheers, Anthony
|
|
#3
06-27-2021, 11:35 PM
|
||||
|
||||
|
More accurately, the holes catch tabs on the small stamped steel guide plates that locate under the wire clips. The guide plates look to be cad plated.
__________________
...................... John Brown This isn't rocket surgery.....
|
|
#5
06-28-2021, 04:28 AM
|
||||
|
||||
|
Not all of the coils that had the holes used the metal pieces with the tabs that fit into the holes. I can't pin down when the change occurred, but the type used on late 60's cars didn't have the tab shown in this picture.
__________________
...................... John Brown This isn't rocket surgery.....
|
|
|
|
Linear Mode
