who extrude hones?

[Chevy454]

Try over HERE. That is where the Pure Stock and Stock Appearing guys hang out...some of those FAST/SA guys could tell ya for sure.

[John Brown]

Pure stockers that extrude hone? Shame, shame!

You might give Greg Gessler a call though. If he stays busy enough doing other peoples heads, intakes and exhaust manifolds maybe he wont have time to make that badd black Buick run any faster.

http://www.gesslerheadporting.com/

[Chevy454]

Hey John:

Any idea if Terry ever found a set of heads? I feel bad, cause I haven't ran across any yet!

[John Brown]

Not yet Rob, Terry's still looking. He bought two different pair, but when he got them they both had been worked on too much to be considered stock. Things like, gasket matched, chambers polished, sand blasted ports etc. They would be ok for most uses, but not for a engine he wants to be able to certify. He's looking for a pair that still have the little foundry marks in the intake ports and as cast port shapes. It may take a while, but someone out there has a pair that will work.