upper a arm washer - Page 2

**Edgemontvillage** · #11 10-28-2019, 04:01 AM

Quote:

Originally Posted by enio45

nice rivot job lloyd!

..I know a guy...

**Edgemontvillage** · #12 10-28-2019, 04:07 AM

Quote:

Originally Posted by 302moz

The a arm in the picture has a 67 , 68 dome style ball joint . I thought Lloyd was restoring a 69?

Here are photos of an original ball joint I removed from the car, my 1969 RS/Z. I replaced them with the same style.

**Lynn** · #13 10-28-2019, 01:53 PM

When was your car built, Lloyd?

**Edgemontvillage** · #14 10-28-2019, 02:58 PM

Quote:

Originally Posted by Lynn

When was your car built, Lloyd?

Its a 2B Norwood car.

**302moz** · #15 10-28-2019, 05:20 PM

Those are not the same . If you clean the grease off you can see the difference. The rivets look good .

**302moz** · #16 10-28-2019, 05:22 PM

The picture Lynn posted is the correct 69 ball joint.

Enoch · #17 10-31-2019, 11:26 PM

Quote:

Originally Posted by ALLZS

1969 Camaro upper control arm bushing washer what is the correct plating

Natural steel painted black.

**Edgemontvillage** · #18 11-11-2019, 12:24 AM

You might like this one better which is what's installed on my 69Z restoration:

**Steve Shauger** · #19 11-12-2019, 03:00 AM

Quote:

Originally Posted by Edgemontvillage

You might like this one better which is what's installed on my 69Z restoration:

Nice detail Lloyd those are the correct 69 assembly line ball joints. John k. Is correct....

**luv2sixty9** · #20 06-03-2025, 11:59 PM

Lynn has the correct 69 ball joints. The one Lloyd used are later NOS and are different with the (5) five spot welds.

The Following User Says Thank You to Edgemontvillage For This Useful Post:
olredalert (06-04-2025)

The Following User Says Thank You to Steve Shauger For This Useful Post:
olredalert (06-04-2025)