Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|
#1
03-09-2025, 03:28 AM
|
|||
|
|||
I know it seems nuts to even consider a trans swap, but I am seriously considering going with a 4L60E when I install the dual quad engine.
Don't have to cut one thing to do it other than the driveshaft (and i can always pick up a used drive shaft to cut down) and can always save the PG in case someone wants to go back original. That OD trans with a lock up converter would work great with the current 3.55 screw.
__________________
Don't believe everything you read on the internet ... Ben Franklin 
|
|
#2
03-09-2025, 03:38 AM
|
||||
|
||||
|
200 4R is a direct replacement for the PG/TH350, no driveshaft cutting, just move the crossmember back, which I'm rather certain you need to do for the 4L60 too. The 4L is also based on the old TH400/700 r4 and has the larger case. Are people able to install that in the tri-five tunnel without cutting/modification ? I know the cast iron PG I removed from '54 was quite beefy and may have been larger than the aluminum case ones ??
My 200 is built for 450 hp 500 torque, there isn't anything that little 283 is going to do to hurt one built right.
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles
|
| The Following User Says Thank You to Too Many Projects For This Useful Post: | ||
big gear head (03-10-2025) | ||
|
#3
03-09-2025, 06:45 AM
|
||||
|
||||
|
A rear transmission mount and crossmember would be needed. Don't know about the strength of the front of the transmission case with the front engine mounts being so far forward though.
__________________
...................... John Brown This isn't rocket surgery.....
|
 |
|
|
Hybrid Mode
