Easy Run Test Stand; Out of Business?

[Lynn]

Here is the panel and frame assembly for the dash. Cut down a couple of small gate hinges, drilled an extra hole in each and attached it to the radiator support.

Cut some 5/8 rebar to length for prop rods. Drilled a hole in one end and tapped it for a 5/16 stud. Drilled a 1/4 inch hole cross ways in the other end to pivot on a 1/4 inch bolt.

I wanted this to be able to fold down against the radiator support when not in use. Takes up less space that way. But, I needed it to fold up and out of the way of air flow, so the "puller" fan could get some air through the radiator!