Easy Run Test Stand; Out of Business?

[Lynn]

Unbelievably, I do not have a 2 1/16 inch hole saw!!!

Guess I have never had to cut a hole for gauges; always used the supplied bracket.

Any recommendations on a quality hole saw?

Not going to waste time hooking up the amp gauge. Besides oil pressure and water temp, was thinking a vacuum gauge, and maybe a fuel pressure gauges; one low pressure set up for carbs, and one high pressure for FI set ups.

Also, just because I already have a spare pair of AFR gauges, I will mount them.

Any other gauges I should consider?

Not looking forward to wiring...