Preservation of a 68 Camaro

[cook_dw]

Over the weekend between periods of rain and Christmas shopping I was able to get a couple things done and started. New pads finally showed up Friday afternoon so I was able to wrap up the drivers door.

Photo 74 - again this was before

Photo 75 - was after wet sanding


Now with new photos

Photo 85 - 87 - After da polishing



I then moved my attentions to getting the remainder of the parts that I had inside the trunk and interior so I can move forward in the cleaning to the insides of the car.

Photo 88 - 89 - Trunk area after removing parts and before cleaning


As you will notice in the previous photos the tail light harness was just hanging outside of the trunk. Well... That was due to me not being able to get the thing out of the trunk drop off. It was hung on something.. So with my trusty archeological digging tools (screwdriver, flash light and magnet) I began the excavation of what was causing the resistance. I also found one of the (what I believe to be the original) barrel nuts that fit into the tailpan for the dealer emblem. And yes I have all the tools soaking in evapo so I can have them with the car as who knows how long they have been in there and I think it's fitting for them to continue to travel with the car just not in the drop off of the trunk..

Photo 90 - 91 - Tools found


Now that the harness is out of the way I figured I'd see just how well the trunk would clean up.

Photo 92 - drivers side cleaned vs untouched passenger side

Photo 93 - Both sides after starting the cleaning process.


Keep in mind this is just the beginning of the cleaning of the trunk and you will more than likely see areas that still need attention but rest assured I will be going back and doing a deeper dive into the trunk over the next few nights if time allows with the holidays quickly approaching.

Photo 94 - 103 - Misc trunk photos

[scuncio]

The trunk cleaned up nicely - wow.

[napa68]

I'm with Tony.....WOW!