Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
Thread Tools | Display Modes |
|
#11
09-21-2020, 10:58 PM
|
||||
|
||||
The extra couple tail panel molding clips arrived today so I installed the moldings and then the tail lights. Now it looks like a Cuda again. It was rather nerve wracking since the clips are the snap-on variety that you have to whap the molding with a rubber mallet to get it to grab over them. Of course they make these clips out of a much harder plastic than the original soft clips used back in the day so it is a very risky proposition to not damage the stainless trim while installing it.
|
| The Following 6 Users Say Thank You to njsteve For This Useful Post: | ||
big gear head (09-21-2020), Lee Stewart (09-22-2020), markinnaples (09-22-2020), RPOLS3 (09-22-2020), scuncio (09-22-2020), X66 714 (09-22-2020) | ||
|
|
Threaded Mode