Rear End Housing Spring Perch Welding

[big gear head]

I've done several of them over the years. I've seen some bad welds on these, and I've seen axle tubes that were torn from hard use. I've had to straighten tubes because of welds, and I've seen some that just needed new tubes because they were just too bad to save. I haven't been able to make the welds look like the factory welds. Those welds were done hot and fast. I don't know anyone in your area, but you can send it to Moser and they will add the spring perches and get the angle right. I don't like the Moser perches. There are better ones out there.