Non-billet roller cam

Home: Goto Homepage.
Subscribed: See all threads you’ve posted in or started.
Today's Posts: Posts made today. Bold = unread.
New Posts: Shows all unread posts since last visit.
New Thread: Newest threads by creation time.

VintageMusclecar · #1 02-27-2018, 02:53 PM

Is the measly cost savings reeeallllyyy worth risking your engine over?

I wouldn't run a cast core roller even at gunpoint. I'd run a flat tappet first, by a long shot.

When it comes to a roller, in my book: Billet core, iron gear pressed on, slide it in, measure & degree it and rock & roll.

Just my $0.02 worth.

KenMaisano · #2 02-27-2018, 05:25 PM

Quote:

Originally Posted by VintageMusclecar

Is the measly cost savings reeeallllyyy worth risking your engine over?

I wouldn't run a cast core roller even at gunpoint. I'd run a flat tappet first, by a long shot.

When it comes to a roller, in my book: Billet core, iron gear pressed on, slide it in, measure & degree it and rock & roll.

Just my $0.02 worth.

I couldn't of said it better!

The Following User Says Thank You to KenMaisano For This Useful Post:
VintageMusclecar (08-29-2022)

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.