Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
Thread Tools | Display Modes |
|
#11
04-28-2017, 03:19 PM
|
|||
|
|||
Lakewood clutch forks are very bulky, plus wrong length bell
Housing pivot ball can position fork to far rearward in bellhousing aggravating the problem. If you use a original GM clutch fork and trim the back ribs slightly it clears the floor, I also used to leave the block plate out because it gives you extra 3/16" clearance , sometimes a 2x4 and a 90832B helps. Last edited by rszmjt; 04-28-2017 at 03:27 PM. 
|
|
|
Threaded Mode