spraying rattle can bare steel paint

[302moz]

the paint goes on top of epoxy primer mixed with reducer as a sealer

[m22mike]

What brand are you using John ?

[302moz]

inline tube brand

[m22mike]

I will not buy anything from them [img]<<GRAEMLIN_URL>>/bs.gif[/img] for reasons I won't go into here. So I never used there brand, most likley it is repackaged anyway. I have had nice results with Seymour paints, but I do not use allot of rattle can paint.

Stainless Paint

[Mr70]

Mike
Can you show us a picture of what you painted with that?
Can it handle High Heat too?

[m22mike]

I do not have anything now but I will do a spray out tomorrow . It should handle normal engine temps.

Mike.

[m22mike]

Here are shots of Seymour Cast Blast and Seymour Stainless Steel, with one shot against a piece of bare steel.

[302moz]

I do not like to use rattle can paint either.But what else can you use to get the bare steel look?

[m22mike]

What parts specifically John ? Sometimes I acid etch with phosphoric acid, blow dry with hot air, then use R.P.M, and after is sets up even some Boeshield.

Mike