Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
|
|
|
Thread Tools | Display Modes |
|
#31
03-02-2026, 06:40 PM
|
||||
|
||||
An opportunity to have the crank drilled/tapped for a bolt and find TDC and install a timing tape and pointer on the harmonic balancer...
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles 
|
| The Following User Says Thank You to Too Many Projects For This Useful Post: | ||
napa68 (Yesterday) | ||
|
#32
03-03-2026, 04:04 PM
|
||||
|
||||
|
I've been putting 327 cranks in my lathe and drilling and tapping the snout. It just takes a few minutes. This gets the hole nice and straight with the crankshaft centerline.
__________________
Freddie 1969 Camaro RS/SS396 (427) 4 speed
|
| The Following 2 Users Say Thank You to big gear head For This Useful Post: | ||
napa68 (Yesterday), olredalert (Yesterday) | ||
|
#33
Yesterday, 03:14 AM
|
|||
|
|||
|
Great thread Tim, keep it going, the info shared here is incredible. I got a 60 fuelie that has been sitting for 20 years and I will have to go through this same path. I used to know how to take these apart and work on them but that was 25 years ago. Forgot it all.
Great looking car, makes me sad I sold a 61 (listed on here under sold cars) that looked underneath similar to yours. Can't keep them all. Cant remember where you are in Wisconsin, but I can vouge for a great engine shop around Milwaukee. -bob
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
