Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
#11
10-08-2025, 07:35 PM
|
||||
|
||||
I brought the heads home to check for spark plug clearance. I did need a "special" socket to install them though!! I think the fact that they are angle plug heads helped for spark plug wire routing too. Note that the headers were still not coated at this point. I was thinking of reinstalling the smog pump and tubes into them but then decided not to!!
And I was also able to get some more painting of parts done!! Flywheel was resurfaced and the Centerforce clutch ready to install. And, finally, back at the engine shop, more parts going on the block!!
__________________
I ain't as good as I once was, but I'm as good once as I ever was. 
|
| The Following 10 Users Say Thank You to '69Novajoe For This Useful Post: | ||
69M22Z (10-08-2025), Arrowsmith (10-08-2025), big gear head (10-09-2025), dykstra (10-08-2025), napa68 (10-09-2025), olredalert (10-08-2025), PeteLeathersac (10-10-2025), RPOLS3 (10-09-2025), Tenney (10-09-2025), Xplantdad (10-08-2025) | ||
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode