Driveshaft...

**WILMASBOYL78** · #1 05-01-2016, 09:05 PM

Looking for a BB 4spd. driveshaft for 68 Nova...Camaro may be the same?

wilma

**YENKO DEUCE REGISTRY** · #2 05-02-2016, 02:52 PM

Are the BB's different than the SB's?

bbbentley · #3 05-02-2016, 03:15 PM

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: YENKO DEUCE REGISTRY</div><div class="ubbcode-body">Are the BB's different than the SB's? </div></div> that was my question as well? There is quite a bit on CRG regarding Camaros though. My experience is other than the th400 the length of 69s (Camaros)is the same for all auto or std. Any engine. Now I think 68 Camaros have a different length. I am at work, but I will consult a Hollander interchange manual I have and see if I can help shed light further. Incidentally , I do have extra d. shafts and one is out of a 69 BB Camaro but it is clocked the same, the same length as one I have out of a 6 cyl. P glide car. And I do understand it is Novas you are seeking, but I will help if I can.

**WILMASBOYL78** · #4 05-02-2016, 04:32 PM

I think the only other factor may be the M22 trans...yoke connection may be different.

thanks...

**jl8z28** · #5 05-02-2016, 05:22 PM

The big block ones I did for Fred were the same as the one's in my Z28s

jasonL78 · #6 05-02-2016, 07:42 PM

I "THINK" the tail shaft is the same its the input shaft that is different on the M22.

**earntaz** · #7 05-02-2016, 08:06 PM

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: WILMASBOYL78</div><div class="ubbcode-body">I think the only other factor may be the M22 trans...yoke connection may be different.

thanks...</div></div>

I think the M22 yoke is the same as a TH400 ...

**BARRY** · #8 05-02-2016, 10:35 PM

1969 Camaros the drive shaft is the same m20 m21 m22 turbo 350 ,,,,, turbo 400 is all buy itself ...1970 muncies had the larger spline

bigsixman · #9 05-02-2016, 11:21 PM

Quote:

Originally Posted by BARRY

1969 Camaros the drive shaft is the same m20 m21 m22 turbo 350 ,,,,, turbo 400 is all buy itself ...1970 muncies had the larger spline

In 1970, only the 454 Chevelle had the large 32 spline output shaft with the 26 spline input. The Camaro and nova still used the small 10/27 spline input/output splines, even on the M-22. In 1971 all the GM Muncie 4 spds received the 26/32 spline input/output spline shafts.

**lbnaz** · #10 05-03-2016, 12:53 AM

What is the center to center measurement of the u joints on the 68 69 drive shaft. I have several for 1970 and a couple smaller drive shafts. Thanks

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.