Driveshaft...
 

Looking for a BB 4spd. driveshaft for 68 Nova...Camaro may be the same?

wilma

Re: Driveshaft...
 

Are the BB's different than the SB's?

Re: Driveshaft...
 

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: YENKO DEUCE REGISTRY</div><div class="ubbcode-body">Are the BB's different than the SB's? </div></div> that was my question as well? There is quite a bit on CRG regarding Camaros though. My experience is other than the th400 the length of 69s (Camaros)is the same for all auto or std. Any engine. Now I think 68 Camaros have a different length. I am at work, but I will consult a Hollander interchange manual I have and see if I can help shed light further. Incidentally , I do have extra d. shafts and one is out of a 69 BB Camaro but it is clocked the same, the same length as one I have out of a 6 cyl. P glide car. And I do understand it is Novas you are seeking, but I will help if I can.

Re: Driveshaft...
 

I think the only other factor may be the M22 trans...yoke connection may be different.

thanks...

Re: Driveshaft...
 

The big block ones I did for Fred were the same as the one's in my Z28s

Re: Driveshaft...
 

I &quot;THINK&quot; the tail shaft is the same its the input shaft that is different on the M22.

Re: Driveshaft...
 

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: WILMASBOYL78</div><div class="ubbcode-body">I think the only other factor may be the M22 trans...yoke connection may be different.

thanks...</div></div>

I think the M22 yoke is the same as a TH400 ...

Re: Driveshaft...
 

1969 Camaros the drive shaft is the same m20 m21 m22 turbo 350 ,,,,, turbo 400 is all buy itself ...1970 muncies had the larger spline

Re: Driveshaft...
 

In 1970, only the 454 Chevelle had the large 32 spline output shaft with the 26 spline input. The Camaro and nova still used the small 10/27 spline input/output splines, even on the M-22. In 1971 all the GM Muncie 4 spds received the 26/32 spline input/output spline shafts.

Re: Driveshaft...
 

What is the center to center measurement of the u joints on the 68 69 drive shaft. I have several for 1970 and a couple smaller drive shafts. Thanks