Anyone using alum heads???

Verne_Frantz · #1 10-11-2005, 02:33 AM

I wasn't sure where to post this, but I was cleaning out the shop (a never ending chore) and ran across 3 new GM thick steel washers for under the head bolts on alum heads. They're left-overs from when I had a set of Booth-Arons heads on my engine. Anyway, since they're real GM I just can't bare to throw them out (I'll never use them). So, if someone needs them, PM me with your address and I'll put them in the mail for you.
I know it's no big deal, but I'm probably the only person I know who's anal enough to think they're worth saving.
Hope someone can use them...

Verne
and NO Bob, I'm not giving away any 409 parts. Get a life!!!

**Hotrodpaul** · #2 10-11-2005, 02:47 AM

I am just starting to assemble my L-78 Camaro engine with L-89 Aluminum heads and was missing a couple of washers. If you could send them to me it would be great. I will send you a PM with my address. Thanks!

Paul

Verne_Frantz · #3 10-11-2005, 03:06 AM

Wow, that was fast. Washers are on their way Paul.

budnate · #4 10-11-2005, 04:32 AM

Vern your not alone..am also a freak and rat hole way to much stuff I will never use....let me know if you find a 12 step prograhm...cuzz I got it bad..

**Hotrodpaul** · #5 10-11-2005, 04:48 AM

Thanks, much appreciated.

Paul

Verne_Frantz · #6 10-11-2005, 05:22 AM

I don't think 12 steps is near enough.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.