67 Firebird LH traction bracket

**1967Z28** · #1 09-20-2009, 02:49 AM

Wanting to purchase the driver's side floor plate spot welded to the body (example as shown in attached picture) and the corresponding bracket which bolts to the two studs which protrude through the bottom of the floor. These are usually found on 400 Firebirds or some 326 4-speed cars. Thank you.

-Jon

Alabamcam · #2 09-20-2009, 03:19 AM

I have an excellent complete LH and RH tractions bars with all original plates and bolts. I will take $300 shipped to lower 48.

Sorry, I do not want to separate

**1967Z28** · #3 09-20-2009, 03:34 AM

PM sent.

Alabamcam · #4 09-20-2009, 06:27 PM

PM response.

Kim_Howie · #5 09-22-2009, 12:27 AM

Did not know there was a L& R bar.

Learn something new everyday.

**iluv69s** · #6 09-22-2009, 05:11 AM

I did not know either until I parted a 67 400-4spd bird.The bars are like little I-beams too..not round or square.Seems like they would hook up....and probably rarer than a 67 camaro traction bar rear

**1967Z28** · #7 09-22-2009, 07:00 AM

I'm still looking for those LH brackets if anybody has them or knows somebody who does.

Thanks,
-Jon

Kim_Howie · #8 09-22-2009, 06:53 PM

I have one ,but I thought it was just a R hand, fitting under the pass side like the camaro. Let me go look. Kim

Kim_Howie · #9 09-22-2009, 07:01 PM

I have the rod and the bracket that bolts to the rear end has casting # 978980 which one is this one L or R ?

**1967Z28** · #10 09-23-2009, 08:18 AM

Not sure. Can you post a picture of it?

-Jon

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.