67 Firebird LH traction bracket
 

Wanting to purchase the driver's side floor plate spot welded to the body (example as shown in attached picture) and the corresponding bracket which bolts to the two studs which protrude through the bottom of the floor. These are usually found on 400 Firebirds or some 326 4-speed cars. Thank you.

-Jon

Re: 67 Firebird LH traction bracket
 

I have an excellent complete LH and RH tractions bars with all original plates and bolts. I will take $300 shipped to lower 48.

Sorry, I do not want to separate

Re: 67 Firebird LH traction bracket
 

PM sent.

Re: 67 Firebird LH traction bracket
 

PM response.

Re: 67 Firebird LH traction bracket
 

Did not know there was a L& R bar. https://www.yenko.net/ubbthreads/imag...iggthumpup.gifLearn something new everyday.

Re: 67 Firebird LH traction bracket
 

I did not know either until I parted a 67 400-4spd bird.The bars are like little I-beams too..not round or square.Seems like they would hook up....and probably rarer than a 67 camaro traction bar rear

Re: 67 Firebird LH traction bracket
 

I'm still looking for those LH brackets if anybody has them or knows somebody who does.

Thanks,
-Jon

Re: 67 Firebird LH traction bracket
 

I have one ,but I thought it was just a R hand, fitting under the pass side like the camaro. Let me go look. Kim

Re: 67 Firebird LH traction bracket
 

I have the rod and the bracket that bolts to the rear end has casting # 978980 which one is this one L or R ?

Re: 67 Firebird LH traction bracket
 

Not sure. Can you post a picture of it?

-Jon