Front End Alignment shims needed
 

looking to buy some 15-20 front suspension alignment shims of the original style that i will restore. this is the style below. If i recall some had a small manufacturing logo on them - not necessary so long as the design is like what i have posted below.


while on the topic, what has been the acceptable finish on them - in the past i usually had them cleaned and preserved in the bare steel. thoughts?

Not that it matters much but these are for a 68 Camaro.

usually they are in 1/8, 1/16 and maybe 1/32.

Currently i have NO shims and lost my stash somewhere, thus the reason i need 15-20 in a variety of sizes to do the alignment.

I'm sure I have some. I'll try to dig around tomorrow.

They are still avail>?

Not sure if the finish could be altered to bare>?

Thank you - i did see those on the net - little rounded on the shoulders, probably have to media clean off the zinc. Good backup solution for what i need. I sure there are numerous of these in bins like i had......I'll see what Charlie comes up with and keep looking for a while.

Have found a few - need more pls!!