Forum: Supercar/Musclecar Discussion
04-24-2024, 01:38 PM
|
Replies: 18
Views: 4,443
Thanks to all for the support, it's sincerely...
Thanks to all for the support, it's sincerely appreciated.
Re: Corvette carbs: Bill pretty much summed it up above, but for the sake of clarity I'll elaborate on the subject.
I've been doing...
|
Forum: Technical & Restoration
02-24-2024, 06:11 PM
|
Replies: 22
Views: 3,613
|
Forum: Technical & Restoration
02-24-2024, 05:43 PM
|
Replies: 22
Views: 3,613
|
Forum: Technical & Restoration
02-24-2024, 05:37 PM
|
Replies: 22
Views: 3,613
|
Forum: Technical & Restoration
02-24-2024, 01:30 AM
|
Replies: 22
Views: 3,613
|
Forum: Technical & Restoration
02-23-2024, 04:55 PM
|
Replies: 22
Views: 3,613
|
Forum: In Memoriam
08-24-2023, 11:00 PM
|
Replies: 6
Views: 2,186
|
Forum: Parts/Memorabilia - For Sale
08-16-2023, 10:59 PM
|
Replies: 12
Views: 3,762
I tried a pair of those on my `67 Chevelle...
I tried a pair of those on my `67 Chevelle mounted on a pair of Centerline AutoDrag 15X8.5" wheels with 4.875" backspace and they hit both inside and outside wheelhouses.
After doing some...
|
Forum: Supercar/Musclecar Discussion
05-23-2023, 05:55 PM
|
Replies: 107
Views: 39,071
|
Forum: Technical & Restoration
04-23-2023, 04:24 AM
|
Replies: 7
Views: 2,377
It's amazing how much fine lint and tiny...
It's amazing how much fine lint and tiny particles of foreign material remain on/in parts even after repeated deep scrubbings, not to mention normal break-in flotsam and jetsam and minuscule slivers...
|
Forum: Technical & Restoration
04-17-2023, 04:48 PM
|
Replies: 7
Views: 2,377
They do work but they're not intended for...
They do work but they're not intended for long-term use. I've used them a couple of times on fresh builds to facilitate post break-in inspection.
If you do install one, you need to watch oil...
|
Forum: Chevrolet
01-16-2023, 08:44 PM
|
Replies: 419
Views: 280,173
|
Forum: Technical & Restoration
01-13-2023, 06:21 PM
|
Replies: 42
Views: 11,703
|
Forum: Lounge
11-23-2022, 11:33 PM
|
Replies: 153
Views: 75,711
|
Forum: Lounge
09-13-2022, 01:35 PM
|
Replies: 2
Views: 2,318
|
Forum: Lounge
09-08-2022, 02:26 AM
|
Replies: 153
Views: 75,711
A Gear Vendors is in the plans, but with...
A Gear Vendors is in the plans, but with everything else I have going on right now, that will have to wait a while.
I've not yet had an opportunity to use the winch--as a matter of fact, I've...
|
Forum: Lounge
09-07-2022, 04:42 PM
|
Replies: 153
Views: 75,711
Most of you have already seen my beloved `95...
Most of you have already seen my beloved `95 C2500 Suburban, but unfortunately it was just recently taken out of commission due to a pretty bad case of frame rot. As I have strong sentimental...
|
Forum: Supercar/Musclecar Discussion
08-13-2022, 10:40 PM
|
Replies: 21
Views: 7,130
Thanks again for all the kind words, it is...
Thanks again for all the kind words, it is sincerely appreciated.
Also, please note that I am not recommending--nor advising against--any other vendors.
One last thing that may be of...
|
Forum: Supercar/Musclecar Discussion
08-12-2022, 03:37 AM
|
Replies: 21
Views: 7,130
A quick fly-by to clear things up a little;
...
A quick fly-by to clear things up a little;
As of February `22, I stopped taking in new Corvette clients. I am still servicing Corvette carbs, but only for previously established clients in good...
|
Forum: Supercar/Musclecar Discussion
07-19-2021, 12:34 AM
|
Replies: 5
Views: 2,565
|
Forum: Supercar/Musclecar Discussion
07-18-2021, 02:30 PM
|
Replies: 5
Views: 2,565
|
Forum: Yenko Chevrolet
01-02-2019, 06:06 PM
|
Replies: 669
Views: 308,179
Rick;
Sorry for the delayed response.
...
Rick;
Sorry for the delayed response.
The engine is .030" over--strangely enough, when we checked the bores on initial examination, they were actually pretty straight--but they were just over...
|
Forum: Lounge
06-08-2018, 03:39 PM
|
Replies: 5
Views: 2,832
|
Forum: Lounge
06-08-2018, 03:11 PM
|
Replies: 5
Views: 2,832
Stepping down as a sponsor of the site.
Before anyone jumps to any conclusions, let me preface that it's nothing personal towards the site or anyone here, I'm just not in a position to continue being a sponsor on the site any more. It...
|
Forum: Lounge
06-06-2018, 03:51 AM
|
Replies: 10
Views: 5,573
Wann'a know what I really miss?
I really miss the good old days when these cars brought people together instead of driving them apart--pun intended.
There will always be rivalries, that's a given--but I miss the days when...
|