Go Back   The Supercar Registry > Search Forums


Showing results 1 to 25 of 500
Search took 0.02 seconds.
Search: Posts Made By: Lynn
Forum: Ebay & other seen ads section Yesterday, 03:24 AM
Replies: 7
Views: 1,988
Posted By Lynn
I think that pic was taken during assembly,...

I think that pic was taken during assembly, before they were tightened.
Forum: Lounge 08-04-2024, 05:09 PM
Replies: 6
Views: 532
Posted By Lynn
My guess would be that cell phone usage was a...

My guess would be that cell phone usage was a factor.
Forum: Technical & Restoration 08-04-2024, 02:56 AM
Replies: 1
Views: 265
Posted By Lynn
Another POV on cam and lifter failure

Interesting:

https://www.youtube.com/watch?v=MbRjAMhCEJk&t=337s
Forum: Supercar/Musclecar Discussion 08-03-2024, 12:12 PM
Replies: 8
Views: 953
Posted By Lynn
I have used "ignore" before on this site. I have...

I have used "ignore" before on this site. I have no idea if it blocks PMs.
Forum: Auctions 07-31-2024, 08:46 PM
Replies: 7
Views: 789
Posted By Lynn
Well, you did own the site. Don't sell...

Well, you did own the site.

Don't sell yourself short.

https://www.youtube.com/watch?v=EeJVTimlyWk
Forum: Lounge 07-31-2024, 08:34 PM
Replies: 31
Views: 1,583
Posted By Lynn
I feel dissed. What about us poor kids who...

I feel dissed. What about us poor kids who couldn't afford a Schwinn?

I am kidding of course, so hopefully no one is bent.
Forum: Technical & Restoration 07-30-2024, 09:27 PM
Replies: 10
Views: 712
Posted By Lynn
If you did not drain the coolant from the block,...

If you did not drain the coolant from the block, then just pulling the heads will allow residual coolant to flow into the cylinders.

If it was clean looking, that may have been what happened. ...
Forum: Ebay & other seen ads section 07-24-2024, 11:17 PM
Replies: 26
Views: 3,313
Posted By Lynn
Several buildings here in downtown Guthrie are...

Several buildings here in downtown Guthrie are like that. Business downstairs, residence upstairs.

In fact, some of them are still apartments up there to this day. That pedestrian door on the...
Forum: Lounge 07-22-2024, 11:25 PM
Replies: 39,053
Views: 9,875,715
Posted By Lynn
Bad Seal

Says it all.
Forum: Chevrolet 07-22-2024, 11:16 PM
Replies: 33
Views: 2,250
Posted By Lynn
Mitch; you rat bastard. I was reading through...

Mitch; you rat bastard. I was reading through Tim's post and was planning on an almost identical response .... except I was going to offer free storage for this red Corvette. Sherri loves the mid...
Forum: Ebay & other seen ads section 07-21-2024, 01:38 PM
Replies: 13
Views: 2,312
Posted By Lynn
Not much to nit pick there. Too late for...

Not much to nit pick there.

Too late for chambered exhaust, but seeing that it has headers with the smog eliminated, not really an issue. After all, I drive my low mileage Z with headers and...
Forum: Ebay & other seen ads section 07-18-2024, 12:07 AM
Replies: 26
Views: 3,313
Posted By Lynn
That was my first question Bill. Is that WS...

That was my first question Bill. Is that WS legit?
Forum: Supercar/Musclecar Discussion 07-15-2024, 09:30 PM
Replies: 13
Views: 2,078
Posted By Lynn
Agree.

Agree.
Forum: Ebay & other seen ads section 07-13-2024, 09:31 PM
Replies: 7
Views: 894
Posted By Lynn
Helluva write up. I am thinking they have...

Helluva write up.

I am thinking they have the 2 and the 4 transposed if they really want to sell.
Forum: Lounge 07-09-2024, 09:55 PM
Replies: 14
Views: 1,131
Posted By Lynn
So cool!!!

So cool!!!
Forum: Lounge 07-08-2024, 01:27 AM
Replies: 24
Views: 6,310
Posted By Lynn
The framework for the dash panel has brackets...

The framework for the dash panel has brackets welded on both sides. I think that makes a great place to mount a throttle control.

Haven't had a lot of time to spend on this, but pleased with the...
Forum: Lounge 07-08-2024, 01:20 AM
Replies: 24
Views: 6,310
Posted By Lynn
Coolant recovery tank mounted.

Coolant recovery tank mounted.
Forum: Lounge 07-08-2024, 01:19 AM
Replies: 24
Views: 6,310
Posted By Lynn
I was thinking that I would make some gizmo to...

I was thinking that I would make some gizmo to retain the prop rods stored in the straight up position; then saw that they hit nothing and were out of the way hanging straight down. So, I just let...
Forum: Lounge 07-08-2024, 01:17 AM
Replies: 24
Views: 6,310
Posted By Lynn
Here is the panel and frame assembly for the...

Here is the panel and frame assembly for the dash. Cut down a couple of small gate hinges, drilled an extra hole in each and attached it to the radiator support.

Cut some 5/8 rebar to length for...
Forum: Lounge 07-08-2024, 01:12 AM
Replies: 24
Views: 6,310
Posted By Lynn
No reason to get fancy with the fuel tank...

No reason to get fancy with the fuel tank "bracket". Just zip tied it to the base.
Forum: Lounge 07-07-2024, 02:02 PM
Replies: 2
Views: 501
Posted By Lynn
Thanks to Steve for making picture posting easier

I know it has been a few years, but just this morning I was reminded of how easy it is to post pics on this site.

I used to have to compress all my pictures (dumb them down) if I were planning to...
Forum: Lounge 07-07-2024, 01:50 PM
Replies: 24
Views: 6,310
Posted By Lynn
Haven't worked on this in a while. I used...

Haven't worked on this in a while.

I used the base of that Delta table saw stand for the radiator support. I had to cut out the gussets on one end and shorten the assembly, then weld the gussets...
Forum: Ebay & other seen ads section 07-06-2024, 02:31 PM
Replies: 2
Views: 1,014
Posted By Lynn
Fun car from the malaise era

Frankly, you don't see those two phrases in the same sentence very often without a negative word thrown in between.

Bet this guy is incredibly upside down in this one, assuming he is the one who...
Forum: Rusted Tires - One Call for Tires & Rims 07-05-2024, 07:13 PM
Replies: 14
Views: 2,253
Posted By Lynn
Rusty: Still delivering to MCACN? If so,...

Rusty: Still delivering to MCACN?

If so, that is another option.
Forum: Ebay & other seen ads section 07-03-2024, 06:52 PM
Replies: 8
Views: 2,211
Posted By Lynn
I can see this one going $150k or better.

I can see this one going $150k or better.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 04:13 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

O Garage vBulletin Plugins by Drive Thru Online, Inc.