Go Back   The Supercar Registry > Search Forums


Showing results 1 to 25 of 115
Search took 0.00 seconds.
Search: Posts Made By: Arrowsmith
Forum: Technical & Restoration 10-24-2024, 01:39 AM
Replies: 6
Views: 3,293
Posted By Arrowsmith
I used bullet resonators before the mufflers and...

I used bullet resonators before the mufflers and dB killing cones in the reducers on my 565 cid Nova. Worked great.
Forum: Supercars/Musclecars-Sold listings 10-10-2024, 11:48 PM
Replies: 12
Views: 4,426
Posted By Arrowsmith
Want it. Can’t swing it. Someone buy it so I...

Want it. Can’t swing it. Someone buy it so I don’t have to think about it …:)
Forum: Supercars/Musclecars-Sold listings 10-10-2024, 09:06 PM
Replies: 12
Views: 4,426
Posted By Arrowsmith
Just an awesome car! Just look at the NCRS...

Just an awesome car! Just look at the NCRS scores...Wow!
Forum: Supercar/Musclecar Discussion 10-09-2024, 01:38 AM
Replies: 8
Views: 3,818
Posted By Arrowsmith
I’m an an anal Nova guy (no secret), but 10 bolt,...

I’m an an anal Nova guy (no secret), but 10 bolt, small block rad support, 1968 short water pump and alternator brackets, what appears to be six/small block heater, 2.56:1 gears (?), guaranteed to...
Forum: Supercar/Musclecar Discussion 10-08-2024, 01:44 PM
Replies: 8
Views: 3,818
Posted By Arrowsmith
Talking Wanna Race? L-O-L ...

Wanna Race? L-O-L

https://i.imgur.com/QOknBPZh.jpg

https://www.yenko.net/forum/showthread.php?t=179421
Forum: Ebay & other seen ads section 09-21-2024, 11:05 PM
Replies: 1
Views: 1,219
Posted By Arrowsmith
Exclamation My 1970 Nova Auction

Hi Folks...My sale fell through with the last buyer, so I put the Nova up on Ebay. Feel free to bid. You might get a deal!

The link is below:

https://www.ebay.com/itm/305795043998


...
Forum: Supercars/Musclecars-For Sale 08-12-2024, 03:53 PM
Replies: 12
Views: 3,528
Posted By Arrowsmith
Smile Sale Pending (Inspection). Going to the best...

Sale Pending (Inspection). Going to the best home possible too.
Forum: Supercar/Musclecar Discussion 08-04-2024, 01:28 PM
Replies: 8
Views: 1,634
Posted By Arrowsmith
Lynn came up with the idea to test the system. I...

Lynn came up with the idea to test the system. I temporarily put him my ignore list and then he sent me a PM. I did not receive it. So it works. Thanks Lynn!
Forum: Supercar/Musclecar Discussion 08-02-2024, 05:00 PM
Replies: 8
Views: 1,634
Posted By Arrowsmith
Angry Block a Member from sending me messages?

Is it possible to block a member from sending me messages? I have someone who, over the years has tried to beat me (and other members of this site) out of cars. A few days ago, he tried to buy my...
Forum: Supercars/Musclecars-For Sale 07-25-2024, 04:40 PM
Replies: 12
Views: 3,528
Posted By Arrowsmith
More photos... Please note: I've had some...

More photos...

Please note: I've had some people express an interest in purchasing without the 565 and the ATI automatic. I'd consider that, and I'm firm at $50,000 as a roller. :)
...
Forum: Supercars/Musclecars-For Sale 07-25-2024, 04:35 PM
Replies: 12
Views: 3,528
Posted By Arrowsmith
Exclamation 1970 Nova Sleeper For Sale

Hi Folks...I'll put this back up for sale. Given my situation, I need to sell it but I can't give I away. Price has been reduced considerably. I'm sure all of you understand.

1970 Nova sleeper...
Forum: Supercar/Musclecar Discussion 04-09-2024, 03:18 PM
Replies: 169
Views: 77,188
Posted By Arrowsmith
Thank you. We appreciate it.

Thank you. We appreciate it.
Forum: Supercar/Musclecar Discussion 04-09-2024, 04:34 AM
Replies: 169
Views: 77,188
Posted By Arrowsmith
Never took it to the track. As some here know, my...

Never took it to the track. As some here know, my wife is seriously ill. Car is for sale and if it doesn’t sell I’ll probably place it in storage.
Forum: Supercar/Musclecar Discussion 04-03-2024, 01:37 PM
Replies: 169
Views: 77,188
Posted By Arrowsmith
Smile Hello again Joe. The back wheel studs in my Nova...

Hello again Joe. The back wheel studs in my Nova are 1/2 x 2.0 - inches. Mark Williams screw in examples, part number 51255. I prefer 1/2-inch studs over the stock 7/16-inch on the rear. Just...
Forum: Supercar/Musclecar Discussion 04-02-2024, 01:47 PM
Replies: 169
Views: 77,188
Posted By Arrowsmith
Smile Hey Joe… in next few days I’ll pop off a hubcap...

Hey Joe… in next few days I’ll pop off a hubcap and get you a measurement.
Forum: Supercar/Musclecar Discussion 03-28-2024, 01:35 AM
Replies: 169
Views: 77,188
Posted By Arrowsmith
Smile Hi Joe. I have Detroit Speed uppers and lowers in...

Hi Joe. I have Detroit Speed uppers and lowers in the car. They do not have a provision to clamp the brake hose, but when I built the car I ran the suspension on both sides through full travel and...
Forum: Supercars/Musclecars-Sold listings 11-25-2023, 04:23 PM
Replies: 2
Views: 2,121
Posted By Arrowsmith
Smile 1956 Mercury M100 Cab & Front Sheetmetal

Mercury M series Cab For Sale

Just an outstanding 1956 Mercury M series cab, doors, hood, grille and other front sheetmetal! Truck was a covered (tarp), very dry Western Canadian farm truck....
Forum: Supercar/Musclecar Discussion 11-13-2023, 10:27 PM
Replies: 14
Views: 3,747
Posted By Arrowsmith
Smile Very nice car! I dig the dog dish hubcaps too,...

Very nice car! I dig the dog dish hubcaps too, but I’m biased:)
Forum: Supercar/Musclecar Discussion 11-09-2023, 10:18 PM
Replies: 169
Views: 77,188
Posted By Arrowsmith
Smile IIRC, they came from Inline Tube.

IIRC, they came from Inline Tube.
Forum: Supercar/Musclecar Discussion 11-09-2023, 07:43 PM
Replies: 169
Views: 77,188
Posted By Arrowsmith
Smile Hi there…they fit nicely with the Competition...

Hi there…they fit nicely with the Competition Engineering connectors I used. If you click to post #137 of this thread you can see the front of the routing. Zero issues at the rear as well….if you...
Forum: Pit Area - Racing 09-20-2023, 02:11 AM
Replies: 24
Views: 15,717
Posted By Arrowsmith
Sounds like you’re headed in the right direction....

Sounds like you’re headed in the right direction. My Smith assassin traction bars are wonderful quality. I’m sure their a-arms are too. Have fun man!
Forum: Pit Area - Racing 09-19-2023, 11:18 PM
Replies: 24
Views: 15,717
Posted By Arrowsmith
Smile How I would do it is to use a travel limiter on...

How I would do it is to use a travel limiter on the front end. Most aftermarket a-arm set ups have them. If the car is working so well, that you need to tie it down a lot and limit suspension travel...
Forum: Pit Area - Racing 09-19-2023, 07:43 PM
Replies: 24
Views: 15,717
Posted By Arrowsmith
Smile Caster is about spindle inclination. An easy way...

Caster is about spindle inclination. An easy way to think of increased caster is like this: your front end setup and alignment is like a mountain bike front end - little or no caster). It is easy to...
Forum: Pit Area - Racing 09-19-2023, 06:59 PM
Replies: 24
Views: 15,717
Posted By Arrowsmith
Smile Your friends are right. For your application, you...

Your friends are right. For your application, you need as much caster as you can get in it, but it won't be much with stock a-arms. With the Detroit speed pieces I have in my Nova (same front...
Forum: Supercar/Musclecar Discussion 09-15-2023, 10:09 PM
Replies: 169
Views: 77,188
Posted By Arrowsmith
Cool Rad Caps!

Here's something for everyone (I think !): I put my Nova together with a DeWitts aluminum rad. It's a beautiful sort-of-stock appearing piece. They also included a cool billet covered rad cap. ...
Showing results 1 to 25 of 115

 
Forum Jump

All times are GMT. The time now is 03:52 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

O Garage vBulletin Plugins by Drive Thru Online, Inc.