Forum: Auctions
07-31-2024, 08:46 PM
|
Replies: 7
Views: 676
|
Forum: Lounge
07-31-2024, 08:34 PM
|
Replies: 25
Views: 948
|
Forum: Technical & Restoration
07-30-2024, 09:27 PM
|
Replies: 10
Views: 613
|
Forum: Ebay & other seen ads section
07-24-2024, 11:17 PM
|
Replies: 26
Views: 3,174
|
Forum: Lounge
07-22-2024, 11:25 PM
|
Replies: 39,053
Views: 9,817,202
|
Forum: Chevrolet
07-22-2024, 11:16 PM
|
Replies: 33
Views: 2,139
Mitch; you rat bastard. I was reading through...
Mitch; you rat bastard. I was reading through Tim's post and was planning on an almost identical response .... except I was going to offer free storage for this red Corvette. Sherri loves the mid...
|
Forum: Ebay & other seen ads section
07-21-2024, 01:38 PM
|
Replies: 11
Views: 1,869
Not much to nit pick there.
Too late for...
Not much to nit pick there.
Too late for chambered exhaust, but seeing that it has headers with the smog eliminated, not really an issue. After all, I drive my low mileage Z with headers and...
|
Forum: Ebay & other seen ads section
07-18-2024, 12:07 AM
|
Replies: 26
Views: 3,174
|
Forum: Supercar/Musclecar Discussion
07-15-2024, 09:30 PM
|
Replies: 13
Views: 2,019
|
Forum: Ebay & other seen ads section
07-13-2024, 09:31 PM
|
Replies: 7
Views: 851
|
Forum: Lounge
07-09-2024, 09:55 PM
|
Replies: 14
Views: 1,073
|
Forum: Lounge
07-08-2024, 01:27 AM
|
Replies: 23
Views: 6,022
The framework for the dash panel has brackets...
The framework for the dash panel has brackets welded on both sides. I think that makes a great place to mount a throttle control.
Haven't had a lot of time to spend on this, but pleased with the...
|
Forum: Lounge
07-08-2024, 01:20 AM
|
Replies: 23
Views: 6,022
|
Forum: Lounge
07-08-2024, 01:19 AM
|
Replies: 23
Views: 6,022
I was thinking that I would make some gizmo to...
I was thinking that I would make some gizmo to retain the prop rods stored in the straight up position; then saw that they hit nothing and were out of the way hanging straight down. So, I just let...
|
Forum: Lounge
07-08-2024, 01:17 AM
|
Replies: 23
Views: 6,022
Here is the panel and frame assembly for the...
Here is the panel and frame assembly for the dash. Cut down a couple of small gate hinges, drilled an extra hole in each and attached it to the radiator support.
Cut some 5/8 rebar to length for...
|
Forum: Lounge
07-08-2024, 01:12 AM
|
Replies: 23
Views: 6,022
|
Forum: Lounge
07-07-2024, 02:02 PM
|
Replies: 2
Views: 479
Thanks to Steve for making picture posting easier
I know it has been a few years, but just this morning I was reminded of how easy it is to post pics on this site.
I used to have to compress all my pictures (dumb them down) if I were planning to...
|
Forum: Lounge
07-07-2024, 01:50 PM
|
Replies: 23
Views: 6,022
Haven't worked on this in a while.
I used...
Haven't worked on this in a while.
I used the base of that Delta table saw stand for the radiator support. I had to cut out the gussets on one end and shorten the assembly, then weld the gussets...
|
Forum: Ebay & other seen ads section
07-06-2024, 02:31 PM
|
Replies: 2
Views: 966
Fun car from the malaise era
Frankly, you don't see those two phrases in the same sentence very often without a negative word thrown in between.
Bet this guy is incredibly upside down in this one, assuming he is the one who...
|
Forum: Rusted Tires - One Call for Tires & Rims
07-05-2024, 07:13 PM
|
Replies: 14
Views: 2,146
|
Forum: Ebay & other seen ads section
07-03-2024, 06:52 PM
|
Replies: 8
Views: 2,151
|
Forum: Lounge
07-03-2024, 03:02 AM
|
Replies: 18
Views: 5,020
|
Forum: Ebay & other seen ads section
07-01-2024, 05:35 PM
|
Replies: 8
Views: 2,151
Nice Lemans Blue 69 Z/28 on BAT
Not much to nit pick here.
Colin's letter indicates there are several threads about the car on this site, but a vin search yielded nothing.
...
|
Forum: Lounge
06-30-2024, 04:19 PM
|
Replies: 51
Views: 10,863
Have seen a few PG transmissions from the 60s...
Have seen a few PG transmissions from the 60s with drain plugs. Otherwise, no.
The "automotive expert journalists" all used to say it was to make certain that instead of just drain and fill, you...
|
Forum: Supercar/Musclecar Discussion
06-30-2024, 02:29 PM
|
Replies: 14
Views: 1,674
|