Forum: Supercar/Musclecar Discussion
Today, 01:28 PM
|
Replies: 0
Views: 72
|
Forum: Lounge
Today, 01:16 PM
|
Replies: 37
Views: 1,264
|
Forum: Supercar/Musclecar Discussion
Today, 12:13 PM
|
Replies: 3
Views: 121
|
Forum: Ebay & other seen ads section
Today, 10:45 AM
|
Replies: 8
Views: 527
|
Forum: Pontiac
Today, 09:43 AM
|
Replies: 240
Views: 131,764
|
Forum: Ebay & other seen ads section
Today, 07:01 AM
|
Replies: 8
Views: 527
|
Forum: Supercar/Musclecar Discussion
Today, 05:37 AM
|
Replies: 3
Views: 121
maybe try:
...
maybe try:
https://www.ncrs.org/services/dealer-code-data.php
|
Forum: Fred Gibb Chevrolet
Today, 03:41 AM
|
Replies: 3
Views: 132
Little Hoss Story
Continued story. Helen was pleased when Lane Automotive selected Little Hoss as one of the 1967 Camaro models they made in the early 2000's. I worked with Lane Automotive with the details required to...
|
Forum: Fred Gibb Chevrolet
Today, 03:22 AM
|
Replies: 3
Views: 132
Little Hoss Story
I am one of the previous caretakers of the Fred Gibb Chevrolet 1967 Z28 known as "Little Hoss". I met Helen Gibb at the 1st Fred Gibb Memorial Car Show in 1999.
I put together a history of the car...
|
Forum: Supercar/Musclecar Discussion
Today, 02:00 AM
|
Replies: 97
Views: 42,851
‘
Back to the total ZL1’s built...
‘
Back to the total ZL1’s built known/reported circa 69/70, this 08/69 Lafferty Ad below notes 67 cars…close but not bang on like the Huebner Ad.
:beers:
~ Pete
.
|
Forum: Ebay & other seen ads section
Yesterday, 09:44 PM
|
Replies: 8
Views: 527
You have to click the link for the full size...
You have to click the link for the full size photos
https://vmp.ebay.com/ebay/viewAllPhotos.aspx?smid=156244749
Then you see an MSD Ready to Run dizzy, Flowmaster mufflers, aftermarket...
|
Forum: Ebay & other seen ads section
Yesterday, 09:43 PM
|
Replies: 8
Views: 527
|
Forum: Supercar/Musclecar Discussion
Yesterday, 08:53 PM
|
Replies: 24
Views: 13,247
BB Camaro AC Suitcase
I lied... Apologies.
The BB Camaro AC Suitcase outer half is also different. The angle off the firewall is different between SB & BB. I did not notice until I had the two pieces side by side.
...
|
Forum: Technical & Restoration
Yesterday, 06:55 PM
|
Replies: 9
Views: 405
|
Forum: Ebay & other seen ads section
Yesterday, 05:36 PM
|
Replies: 8
Views: 527
Nice car. I am not a Nova expert although I've...
Nice car. I am not a Nova expert although I've had a few big block Camaros and Impalas. Other than the usual factory big block identifiers like correct radiators, rear ends (12 bolts ) block, heads,...
|
Forum: Lounge
Yesterday, 05:33 PM
|
Replies: 37
Views: 1,264
|
Forum: Member's Rides
Yesterday, 04:04 PM
|
Replies: 196
Views: 113,512
|
Forum: Technical & Restoration
Yesterday, 03:57 PM
|
Replies: 9
Views: 405
I should add, for metal parts I will paint, I...
I should add, for metal parts I will paint, I still use the diamond to achieve the equivalent 80 grit texture for the paint to grab. It's still the best for heavily rusted and pitted steel and will...
|
Forum: Technical & Restoration
Yesterday, 03:49 PM
|
Replies: 9
Views: 405
I used to use the black diamond but switched to...
I used to use the black diamond but switched to this several years ago. I run the air pressure at 40 psi at the gun to prevent metal marking. It will remove heavier rust/paint at up to 90 psi too,...
|
Forum: Supercars/Musclecars-For Sale
Yesterday, 03:36 PM
|
Replies: 18
Views: 2,224
|
Forum: Technical & Restoration
Yesterday, 03:29 PM
|
Replies: 9
Views: 405
|
Forum: Member's Rides
Yesterday, 02:28 PM
|
Replies: 196
Views: 113,512
Looks great!
Small detail but I think the...
Looks great!
Small detail but I think the fasteners on the upper ball joints are reversed - the riveted looking part goes in from the top of the ball joint and the retaining nuts on the bottom...
|
Forum: Supercar/Musclecar Discussion
Yesterday, 02:22 PM
|
Replies: 8
Views: 621
I was young and impressionable during the...
I was young and impressionable during the pro-street era... really loved those cars at the time, but my tastes have changed and I'm right there with you on the Day 2 style now!
I went to High...
|
Forum: Supercar/Musclecar Discussion
Yesterday, 02:22 PM
|
Replies: 8
Views: 621
Brake stuff
Daveg, I assume you’re talking about the spindle. When he got the car it had an aftermarket disc brake system on all four. He didn’t have the Mopar backing plates and other factory items so he got an...
|
Forum: Supercar/Musclecar Discussion
Yesterday, 01:54 PM
|
Replies: 131
Views: 62,263
|