Few parts in need

[cook_dw]

Huge thank you goes out to Rich on the insulation clips. Thanks again!

[cook_dw]

Need to add an original assembly line 67/8 trunk mat the need list. Condition can be whatever.

[scuncio]

Are the deluxe water shields any different than standard interior shields?

[X66 714]

Originally Posted by scuncio

Are the deluxe water shields any different than standard interior shields?

Yes. The deluxe have a plastic pocket where the door release handle is located...Joe

[cook_dw]

Adding to the list of needs:

- 67/68 Gas tank to filler neck rubber connector hose (GM #597114 / 3735503)

[jwcarguy]

Originally Posted by cook_dw

1st gen Camaro parts needed:

Please email me if you have any of the items below with the subject line "Camaro Parts"

cook_dw"at"hotmail.com

replace "at" with @

List updated.

I am in need of the following.

- deluxe door panel water shields
- 11/67 or 12/67 tinted or non tinted windshield code needs to be CZ-10 or VZ-10
- Dec 67 small block heater core non ac
- original non ac firewall pad
- 3935948 - Astro vent connector 1 qty
- assembly original 67/8 Camaro trunk mat - condition doesn’t matter
- 67/68 Gas tank to filler neck rubber connector hose (GM #597114 / 3735503)

Thanks

I have an original Harrison Heater core stamped "67 M "

I thought that I had that Astro Vent Connector hose, but I don't
I have a few large bins full of heater and a/c ducts / pieces for 67-9 Camaro and some Chevelle

you can have the heater core for free, just pay shipping (large USPS Priority flat rate box should work approx $22)

[scuncio]

Very nice - those dated heater cores are good rebuild candidates.

[jwcarguy]

Originally Posted by scuncio

Very nice - those dated heater cores are good rebuild candidates.

I have a few of them, this is only 67, others are 68 Harrison cores, may have a 69, but have to keep that for the X66 project car

Thanks, Jeff

[cook_dw]

Nice! I’ll pm you for your PayPal info!

[cook_dw]

Still in need of parts. Heater core back on the list as well.