#21
|
||||
|
||||
Air is the easiest way, but how much pressure are you using ?? You need to regulate the air down to under 5 lbs..2-3 is all you need to balloon the seal, once you have positioned the piston JUST right on it, anymore pressure than that, and you are fighting it to push the piston in. Also, as soon as the seal balloons around the piston, shut the air off.
Have a film of brake fluid on the o-ring to help the piston slide in.
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles |
#22
|
||||
|
||||
Just out of pur curiosity does anyone make a stainless steel bleeder ?
__________________
1969 SS 396 300 deluxe post car 1969 SS 396 300 deluxe hardtop 1969 SS 396 chevelle 1978 chevy shortbed step side 1983 chevy shortbed 1985 chevy shortbed If a hammer and duct tape wont fix it u have electrical problems! |
#23
|
|||
|
|||
As a follow up, my friend who ownes a small auto repair shop and his very experienced mechanic did the air/balloon method for me,
although it wasnt easy....took maybe five minutes with one guy controling the air blower and the ace mechanic manipulated the piston until he could get the dust seal rubber to come around the edge of piston....He was using high air pressure and wouldnt listen to me about trying low pressure...............
__________________
Chuck Sharin [email protected] Auburn,WA (30 miles South of Seattle) 70 Camaro R/S Z-28, L-78, R/S SS 69 Camaro COPO "recreation" |
Thread Tools | |
Display Modes | |
|
|