|
|
|
#101
07-18-2024, 01:47 PM
|
||||
|
||||
How's the car coming along Paul?
|
| The Following User Says Thank You to napa68 For This Useful Post: | ||
PeteLeathersac (07-18-2024) | ||
|
#102
07-18-2024, 01:55 PM
|
||||
|
||||
|
Proving Ground test cars had similar Bowtie decals.
|
| The Following 7 Users Say Thank You to 1967Z28 For This Useful Post: | ||
1967 4K (07-18-2024), dykstra (07-19-2024), juliosz (07-18-2024), markinnaples (07-18-2024), olredalert (07-19-2024), PeteLeathersac (07-18-2024), Tenney (07-18-2024) | ||
|
#103
07-18-2024, 10:33 PM
|
||||
|
||||
|
It’s coming along nicely, Tim. Just finishing up on the wiring and will then dress the engine compartment. Just got a call from my stainless/chrome guy and my plating is done….need to pick it up and (ugh) pay. I’m terrible at documenting the progress and posting pics. I’ve been taking short videos and sending to the original owner.
On a separate note, I’m thankful this project came with three tubs of NOS fasteners. I didn’t realize how hard it is to find some of these like speedometer cable clips as an example. Quote:
Last edited by juliosz; 07-18-2024 at 10:42 PM.
|
| The Following 8 Users Say Thank You to juliosz For This Useful Post: | ||
1967 4K (07-19-2024), 1967Z28 (07-19-2024), 67since67 (07-19-2024), 69M22Z (Yesterday), dykstra (07-19-2024), napa68 (07-19-2024), olredalert (07-19-2024), PeteLeathersac (07-18-2024) | ||
|
#104
Yesterday, 02:57 PM
|
||||
|
||||
|
Making progress slowly but overall pleased so far:
|
| The Following 10 Users Say Thank You to juliosz For This Useful Post: | ||
169indy (Today), 1967 4K (Yesterday), 1967Z28 (Yesterday), 69M22Z (Yesterday), big gear head (Yesterday), Dave Rifkin (Yesterday), dykstra (Yesterday), olredalert (Today), RPOLS3 (Yesterday), Tenney (Today) | ||
|
#105
Yesterday, 03:02 PM
|
||||
|
||||
|
Looking for some ideas on my fan shroud. No damage other than scratches. Has anyone had any luck with reconditioning these?
|
| The Following 3 Users Say Thank You to juliosz For This Useful Post: | ||
|
#106
Today, 04:47 PM
|
||||
|
||||
|
I would try successive fine grades of wet dry sand paper on a block to attempt to smooth the gouges however I think you can not remove enough material to eliminate them.
another option https://www.gmpartsdirect.com/oem-pa...shroud-3893812
__________________
69 Los Z11 68 SS/RS 396/325 68 Los Z28 
|
| The Following User Says Thank You to 169indy For This Useful Post: | ||
juliosz (Today) | ||
 |
|
|
Linear Mode
