69 Z/28 Day II Project (Air Force Brat)

[TimG]

I NEVER get tired of looking at pictures of this car. Please keep posting more.

It's funny, my wife looks over my shoulder sometimes and always smiles and says "more car porn"?

[NorCam]

So...

Been taking my sweet time getting all the little things dialed in with the car and really, I've been in no hurry to get it out for additional shake down runs. In saying that, I've had my share of little annoyances and things that try and fight back...but finally, I torqued down the front suspension this week, lubed the grease zerks, double checked all the fluids, double checked the driveline & suspension settings, and finally timed the motor last night before adding a couple gallons of fuel. So I'm now ready for a little shake down run to ensure all is good...right?

Nope...not so fast says some little Noid. You forgot something...and it's going to cause you some grief. Maybe not enough to stop you in your tracks, but enough to humble you, and remind you that you're human. (grrrrr)



Direct link for those with browser issues or restrictions. https://youtu.be/RN0s863GRBY

[big gear head]

I could hear the M23. I love that sound. Was that a rare deep groove pulley? Glad it didn't do any more damage.

[NorCam]

Originally Posted by big gear head

I could hear the M23. I love that sound. Was that a rare deep groove pulley? Glad it didn't do any more damage.

It was suppose to have been a real one and came in a parts swap but I think it was a repop. I'm just lucky it didn't come off when I was setting the timing as I'm sure it was up around 4K when I had the light on it to check total advance. The nut must have come off when I fired it up because it was laying under the lift and I just swept it out earlier in the afternoon...so it had to have just come off when I pulled it out to time the engine.

[NorCam]

On a good note...I picked up a nice pair of original Jan 28th YH wheels yesterday through eBay. Nicely restored, no pitting and they spin true. Whenever I can get some new Goodyears without all the backorders, I'll get some rubber ordered up for them.

[napa68]

You didn't screw around getting the wheels!!

Glad you did hurt anything else with the PS pump pulley. That could have sucked @ 7000 plus!

Sounds bad ass

[ruralrte66]

I have (and everyone on sYc) so enjoyed this thread, watching the build of this Day 2, X77, 76 76, 714, Z28 in just 1 year. Just amazing, The Best!!!!!

Gregg

[NorCam]

Thank you Greg. I really enjoy sharing it all as well.

Best part is getting to drive it at the end. Then it's always the age old question for me.

What next?

[Zedder]

Great video Graeme! Glad you dodged a bullet with that pulley!

[frankk]

Thanks for posting the extra link Grame. What next you ask......well you park it in the garage and the next day you drive it again and then park it and the next day after that you drive it again. And so on!