Upper ball joint rivets - Page 3

RonNova396L34 · #21 02-20-2003, 02:45 AM

Marlin,
If you read Nova Times June 2002 issue page 14, you can read where I got my rivets at.
Ron [img]/ubbthreads/images/graemlins/grin.gif[/img]

Nova Research Project · #22 02-20-2003, 02:45 AM

Enoch,

I could use a set. My ball joints do not have the slots.

Thanks, Greg

fpcopo · #23 02-20-2003, 02:51 AM

Flying "A" in Omaha has the rivets and also has a fixture to install them. They can do Camaros,Chevelles, Vettes, fullsize, and 55-57s. 402 593 1090. They did mine and came out perfect. It's best to wait to paint the a frame til last because the rivet has to be heated red and bucked in place. Then the cooling shrinks it tight.

Enoch · #24 02-20-2003, 03:14 AM

FYI I can install the rivets also, I just thought you were looking for a supplier of rivets. As the one I had it cost only pennies per rivet.
I still have almost 1000 of them and will send out sets to those intrested or if you want them installed let me know too. e-mail address is [email protected] I'll get them out asap.

Jeff H · #25 02-20-2003, 01:33 PM

I wasn't sure which rivets you had and assumed they were the Corvette rivets. Since I know my car won't be 100% factory correct I wasn't too concerned, but the closer it is, the better.

T Billigen · #26 02-21-2003, 08:51 PM

Does anyone have some NOS upper and lower ball joints for sale? (69 camaro)

resto4u · #27 02-22-2003, 12:03 AM

I have seen them on e-pay! Ones i have seen, went for $30-60. Roger

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.