Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
04-09-2007, 05:58 AM
|
|||
|
|||
Re: Crane Cams points conversion
I used the crane system for about 6 months with a stock coil. I never raced the car, but it ran OK. I switched back to the single point setup.
__________________
Dean 
|
|
#2
04-10-2007, 06:35 AM
|
|||
|
|||
|
Re: Crane Cams points conversion
Darren, et al: be weary of the rev limiter on the Crane unit, word in the Pure Stock circles from dyno testing is that they start coming in quite a bit earlier than where you set them. Not like an MSD soft touch, which starts pulling back at a set #...
|
|
#3
04-10-2007, 05:27 PM
|
||||
|
||||
|
Re: Crane Cams points conversion
I'll keep and eye on that. When I installed mine I set it for 4500 to test and it hit there every time. Thanks for the heads up Rob...
__________________
1969 Z28 1972 Corvette
|
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
