Re: wanted: a project muscle car
Hi Dan, just thought i would throw this at you, I have a 1967 chevelle ss 396 350hp m21 4:10s it is Gold with black vyn top black bucket seat interior with console and blinker tack, also has tilt wheel and am/fm power steering, the car has 28000 original miles, it was a michigan car so it had some rust issues but the body has all NOS sheet metal installed (tail panal,quarters, outer wheel houses, trunk floor,extentions, rh door, lh door skin, front inner and outer fenders, radiator support, latch support, lower grille filler, tail lamp housings, duthman panal, you get the idea, all gm parts installed correctly, the engine has never bean apart just cleaned and painted, the original covers were rechromed and the holley restored, nos air cleaner, i have most of the rest of the trim parts for the car NOS includeing ss grille,bezels, extentions, tail lamp bezels, door latches, hood hinges, latch, door handles, all moldings,lenses, emblems, interior trim, +++++ the seats are all done, powder coated springs, legendary covers,door panals, carpet, NOS bumpers, the trans and rear end have all new gm parts installed by a local trans shop, all in all about 40.000 in paper that has bean spent so far, alot of time searching down all of this NOS all #s match, pm me if interested, i would sell the car without all of the Nos trim if you wanted to go the repop route and save some money or the whole ball of wax 34k
__________________
Rich Straub
raiv 69 judge, ra3 70 judge, 71 judge,74 SD trans am,71 cudas, 67 189 Corvette roadster, Quicksilver 68 HURST
z-10 396 camaro, 69 HEMIBEE
|
11-03-2006, 03:21 AM
Hybrid Mode
