Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|
#1
09-26-2005, 11:14 PM
|
|||
|
|||
Re: Engine pad re-stamp???
It is a 4 bolt main block and no VIN can be seen at bellhousing flange, by me anyway. I know little about 1970 Camaro's and have not looked at rear axle yet. The trim tag indicates it is a Norwood car but not sure what should be stamped on flange (N, etc.). Trying to get the "warm and fuzzy" about what I have before pumping lots of $$ into resto as I am too anal to do it half-(you know).
__________________
'70 L78 NOVA SS '77 Bronco 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
