Upper ball joint rivets

[Enoch]

When I logged on this morning I had several responces to the rivet offer. So when I got into the shop I called my supplier to see how fast I could replenish my stock only to find out they moved w/out a fowarding address. I was going to post thier phone # and web site so you all could get them. So till then I'll be happy to send out a those needed right away. In the meantime please give me a week or so to find the source again to supply all your needs.


Marlin, You will have to remove the control arms to do this. Another thing is, once riveted in and reinstalled you should have the front end realigned (Just to be safe) even if you mark and put the shims back in the same places. The ball joint could move putting in the rivets. I'll be happy to pass a set on at cost to help out. Once you find out if it is 1/4" rivets you need.

[Nova Research Project]

Enoch,

I could use a set. My ball joints do not have the slots.

Thanks, Greg