![]() Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
![]()
JoeC;
You have the correct shifter for the a/t Yenko Deuce Novas. All original a/t cars found (except dual gate optioned cars) have the Hurst Auto Stick shifter, dual pattern engraved in white on a black knob, very long chrome arm, large black boot with square stainless retaining ring, and the stainless plate with 'H' cutout / red plastic underneath. It took us awhile to determine that this type of shifter was the correct one because there are only 19 a/t cars found, and not all of them had the Auto Stick. The shorter stick, dual gate shifter was an $80 option on top of the $85 a/t option and you didn't even get the console!! mnyenko; I have a picture of your car's interior, it appears that you have the correct shifter installed. M
__________________
Marlin 70 Yenko Nova-350/360, 4speed M21, 4.10 Posi (Daddy's Ride) 69 SS Nova-396/375hp, 4speed M20, 3.55 Posi (Benjamin's Ride) 67 RS Camaro-327/250hp, 2speed Glide, & 3.08 Open (Danny's Ride) |
#2
|
|||
|
|||
![]()
Here is a picture of an NOS Hurst Shifter Super Boot I just pulled off the shelf.The plastic covering obscured the photo a little.
Dave http://albums.photopoint.com/j/View?...268&p=54734861 [Edited by whitetop (10-01-2001 at 05:57 PM).] [Edited by whitetop (10-01-2001 at 05:59 PM).] |
#3
|
|||
|
|||
![]()
Dave, Is the Hurst boot sold today use the same rubber part and will the old trim parts fit on the new rubber boot?
|
#4
|
|||
|
|||
![]()
Joe
Everything is the same except the middle plate which is engraved on the new one with the H. The old plate with pop right into the new boot. The biggest problem with the ones at the swap meet are the plates are bent or rusty and the red H piece of plastic is missing. Dave |
#5
|
|||
|
|||
![]()
Marlin,
Howdy! Long time no talk! I am currently writing a series of magazine articles on various OE Hurst shifter applications. I saw the reference to the special Hurst shifter in the Duece from the article on your car. Did the special shifter have a part number from Hurst? Does the Duece shifter use the same offset carrier as in the Camaro? Do you have any literature from Hurst on the shifter? Thanx ![]() Alan |
#6
|
|||
|
|||
![]()
Alan,
I just purchased the two "Chevrolet By The Numbers" books that I needed to complete the set, the 1955-59 and the 1960-64, the books are great! Thank you. Andrew |
#7
|
|||
|
|||
![]()
It sounds like the Hurst Super Boots are still available. Where is a good source? Does this boot just fit over the other boot? I never thought such a discussion would evolve from a topic like this. Just shows that there are no stupid questions!!
|
![]() |
Thread Tools | |
Display Modes | |
|
|