Alllllllrighty. Moving ahead it's time to figure out flooring. And while composite weathered birch really would look good in here, I'm thinking the floors need some better rigidity. The floors are pretty easy to form. Easy...
.... is anything on this easy?!
However, there are stamped impressions that I need to make which will require me to do some modifications to my press to accommodate the larger panels. I will also need to use the bead roller on a few panels too.
The trick here is also to leave enough room to run the exhaust without it hanging below the frame along with enough recess to make sure I'm not looking clear across the top of the windshield while driving. The seat has to be in the perfect spot. Should be easy enough. Should be....
So after all the fab work here's the pans roughed in. Nothing welded up yet. Why not? Everthing gets mocked up first then the whole car gets disassembled and I'll weld inside out. Of course before the exterior skins go on I'll get some nice pics of the structure and compare them to the ones I have of an original. One thing the 507 has are heat shields that run the entire length of the floors under the interior. Those will be formed later.
Stay tuned.... more to come!
Cheers
Dave
10-24-2022, 07:26 PM
Threaded Mode