Chevelle updates

**napa68** · #1 03-02-2022, 09:38 PM

I believe the piston is tapered inside.

**RPOLS3** · #2 03-02-2022, 10:48 PM

Quote:

Originally Posted by napa68

I believe the piston is tapered inside.

So the tool should self center when screwed in due to the taper?

**Too Many Projects** · #3 03-02-2022, 11:24 PM

Hopefully...
I would put a mild radius on the very end, so it isn't such a sharp edge.
Yes, leave it in until done bleeding.

**napa68** · #4 03-04-2022, 02:41 AM

Quote:

Originally Posted by RPOLS3

So the tool should self center when screwed in due to the taper?

Yes

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

The Following User Says Thank You to RPOLS3 For This Useful Post:
napa68 (03-04-2022)

The Following User Says Thank You to Too Many Projects For This Useful Post:
RPOLS3 (03-03-2022)

The Following User Says Thank You to napa68 For This Useful Post:
RPOLS3 (03-04-2022)