Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
02-01-2020, 05:27 PM
|
||||
|
||||
And the rear bars, comparison
9/16" bar:  3/4" bar: 
Last edited by njsteve; 02-01-2020 at 05:34 PM. 
|
| The Following 5 Users Say Thank You to njsteve For This Useful Post: | ||
napa68 (02-03-2020), olredalert (02-18-2020), RPOLS3 (02-02-2020), scuncio (02-03-2020), Xplantdad (02-18-2020) | ||
|
#2
02-18-2020, 06:06 PM
|
||||
|
||||
|
Steve,
Any pics of your exhaust hangers for the muffler? I'm curious to see how yours was done. Took your advice...........RA manifolds and Pypes on the way. Thanks, Tim
|
|
#3
02-18-2020, 09:35 PM
|
||||
|
||||
|
I will take a look at the archive. Pypes themselves did the install in PA. They employed a hanger bracket that uses the factory slip-in rubber bushing at the top, near the gas tank hangers.
|
|
#4
02-18-2020, 10:45 PM
|
||||
|
||||
|
You can just barely see the edge of them but they are the u-shaped brackets that slip under the top exhaust clamp and also slide into the bulkhead rubber grommet bracket above the muffler. Pypes sells the brackets. I think they are an extra cost items not included in the kit. (of course)
Here's the old video of the sound: https://youtu.be/ptAubfuN8N4 and the installation: https://www.youtube.com/watch?v=3XsgWVUQ48s Last edited by njsteve; 02-18-2020 at 11:01 PM.
|
| The Following User Says Thank You to njsteve For This Useful Post: | ||
napa68 (02-19-2020) | ||
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
