3 phase milling machine to single phase.

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.

Join us now! Register now to join The Supercar Registry community!

Yenko.net

		The Supercar Registry > General Discussion > Lounge
3 phase milling machine to single phase.

Thread Tools

Display Modes

06-09-2018, 02:04 AM

Billohio Billohio is offline

Yenko Contributing Member

Join Date: Jul 2012

Location: Ohio

Posts: 1,714

Thanks: 998

Thanked 379 Times in 246 Posts

It is a 208 volt. We have a c drives running big motors on our grain system but hated to spend that much on this. Grain system has one 50 hp motor so we get along good there. This will be a huge improvement over our antique drill press that uses channel locks for a vise!

Attached Images

__________________
Bill

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT. The time now is 10:57 PM.