Paint on fender wells and firewall

[Lynn]

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: dakotakid</div><div class="ubbcode-body">I have a '69 Berger Camaro with a fairly decent restoration. One problem though...when the restoration was done, the fender wells and firewall were painted gloss black. Rather than take everything apart and redo it all, is there a way with some type of compound or mild chemical to &quot;flatten&quot; the paint somewhat (without removing it), so that it has a semi-gloss satin appearance? Thanks. </div></div>

On an inconspicuous place, try scrubbing it with Comet abrasive cleaner using a sponge. Seems like I did this about 30 years ago on a part that was too glossy. I believe a very fine brass wool dipped in water might accomplish the same effect. Don't use steel wool, as the fince particles left behind will rust residue.

[m22mike]

I was going to even suggest trying some very course rubbing compound. Anything with course abrassive is going to give it a hazy apperance, may look funky when the sun hits it ?

Mike

[x Baldwin Motion]

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: m22mike</div><div class="ubbcode-body">I was going to even suggest trying some very course rubbing compound. Anything with course abrassive is going to give it a hazy apperance, may look funky when the sun hits it ?

Mike </div></div>

That's correct Mike, any abrasive will show scratch(swirl) marks on a former gloss finish when the sun hits it. Maybe a product like Prepsol or another cleaning solvent with isopropoyl alcohol. Like above, test a small area.

[Alss]

I dont think anything will work..you can never replace a sprayed finish with any kind of rubbing..its impossible to make all the tight areas uniform..bite the bullet and do it the right way..the car deserves it!

[Schonyenko2]

I agree with Albert.