67 Z-28 Day 2 "Trans Am" restoration

**iluv69s** · #1 02-07-2010, 05:22 PM

I have this factory glass hood that has been 'hanging around' also that I am going to paint at the same time as the flat hood...for future use!!

**iluv69s** · #2 02-07-2010, 05:26 PM

and my ultimate goal is to build a 'hemi' motor with these heads that I have managed to hold onto...unfortunately I have yet to locate an intake base...but at some point when i get the hemi motor built, I will probably go with a Weber or injection setup..I really like the look of the 'Cherokee' camaro motor. This is still in the dream stages though...too much $$$ for now...but it will happen someday I hope!!

..anyone know of a hemi intake base for sale...findes fee paid!! Thanks

**iluv69s** · #3 02-07-2010, 05:27 PM

...the rear that came with the car is a 3.73 12 bolt..but I do not think original to the car....

**iluv69s** · #4 02-07-2010, 05:29 PM

I saved this 68 dated heavy duty service JL-8 rear to use..but I wonder if I will have rear hop problems without the traction bar ??? I was considering welding a bracket to this rear and using a bar..what do you guys think???

**iluv69s** · #5 02-07-2010, 05:32 PM

the car came with no guages..so I will use this NOS tach..I always dug these tachs..although not so practical...

**iluv69s** · #6 02-07-2010, 05:33 PM

I will be using original heater and radio delete set-ups also..(makes the build easier too!)

**iluv69s** · #7 02-07-2010, 05:35 PM

spare parts for the build....just thought it was a neat pic too!!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.