Question about Slicks....

Home: Goto Homepage.
Subscribed: See all threads you’ve posted in or started.
Today's Posts: Posts made today. Bold = unread.
New Posts: Shows all unread posts since last visit.
New Thread: Newest threads by creation time.

**markjohnson** · #1 01-05-2010, 06:42 AM

http://www.radirwheels.com/contents.htm These Radir slicks are great and naturally you'll wanna avoid the rain but with their 4-ply sidewall, they actually drive quite nice compared to a wrinkle-wall slick. Now, I ran the 10.00 x 15's that are close to 30 inches tall and it really took me a long time to get the air pressure situation right. I started like I normally would with about 10-11 LBS. but I never started getting a nice even footprint across until a little over 30 LBS. Yeah, I know.......that's a lot of air pressure for a slick, but that's when they started finally leaving a decent footprint and actually ripped off my housing perches due to their effectiveness.

**PxTx** · #2 01-05-2010, 06:57 AM

Looked at the link, but the frames configuration may have messed it up a little. Do they offer a slick without the white-walls?

**Mr. Chevy** · #3 01-05-2010, 06:59 AM

Doesn't look like they do. They even note you can turn in the whitewall if you don't want it showing..

Rich

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.