1st gen Big Block Crossmember

**YENKO DEUCE REGISTRY** · #1 04-03-2009, 08:38 PM

I measured: SB = 15", BB = 15.5" so it's a half inch of difference regardless of where you measure from.

**Kurt S** · #2 04-04-2009, 09:32 AM

With pics.

http://www.camaros.org/trans.shtml#Crossmembers

Plowman · #3 04-04-2009, 04:00 PM

You can use a three hole trans mount,put the center hole in the right hole. Good luck. Paul

beater68427 · #4 04-04-2009, 06:33 PM

Thanks for all the help!! Should be easy enough I will just cut on side over 1/2 inch and forward 3/4 inch take the piece out flip it around and weld it back in

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.