Commercial parts tumbler

[CamarosRus]

JM would have those flame sprayed with ALUMINUM so they wont rust
and the 1200 degree VHT paint for the cosmetic "LOOK"

Mark, How does the bake abrade and sending them through a steel shot blaster
differ in the end results ???

Mark, Do you experience yourself send stamped steel parts (vs cast iron/cast alum)
through your guys shot blaster. I sent misc parts through for 90 seconds...and they
came out perfectly clean with a SLIGHT profile on the metal.....Have not epoxy primed
yet so honestly dont know if Rick would find acceptable.

My new "place" (a different business) uses very fine shot in their steel shot blaster
but I yet to try any stamped steel parts yet..........