1st design off road cam #3927140 Vacuum Issue?

[cdn454LS6]

Hi Everyone
Rebuilding my stock 302 with all the original parts, pink rods, 1178 crank, 0 rockers, 11-1 stock pistons, single DZ carb etc etc.
Can I use the 1st design off road cam #3927140 in this stock engine for street use with 410 rear.
Can I still use pump gas 94 And is it possible to have a vacuum problem at all?
Thanks very much in advance for your help.
Ken

[beater68427]

My JL8 has that same cam seems to work fine I actually like the bleed with the overlap seems to be a bit of a ease with the comp ht. with pump gas, no ping brakes work great!!

[Bill Pritchard]

In the mid 70's I built an LT1 with that cam and had it in a 69 Camaro with power disc brakes. Had no lack of vacuum for the brakes, so you should be fine.

[Andy]

A guy on camaros.net just put one in his car along with headers and he loves it. It really sounds strong in his video. I think he has a gardeners chambered exhaust too.

https://www.youtube.com/watch?v=WTgT0VCytGc

https://www.youtube.com/watch?v=iXK-lTkRXBY

[Salvatore]

4:10's may be a little tough to pull out with the car. Unless the trans was a M20 box. I would go to 4:56's with an M20 box and that car would be mean. Also I like pressed in wrist pins. A little safer and it doesn't have much, if anything to do with performance. 302's are all about proper gearing. We already know how much they rev!

[Steven J]

My brother had a stock, except for the off road cam, 70 1/2 Z-28. 4 speed, 4.10 gear. It was fine with power brakes, had a great sounding idle, but 4.56 gears would have been better with that cam.